ProForm 5.0 Crosstrainer Treadmill User Manual page 11

HOW TO TURN ON THE POWER
IMPORTANT: If the treadmill has been exposed to
cold temperatures, allow it to warm to room tem-
perature before turning on the power. If you do not
do this, the console displays or other electrical
components may become damaged.
Plug in the power cord
(see page 9). Next, locate
the reset/off circuit breaker
on the treadmill frame near
the power cord. Make sure
that the circuit breaker is in
the "reset" position.
IMPORTANT: The console features a display demo
mode, designed to be used if the treadmill is dis-
played in a store. If the displays light as soon as
you plug in the power cord and switch the circuit
breaker to the reset position, the demo mode is
turned on. To turn off the demo mode, hold down
the Stop button for a few seconds. If the displays
remain lit, see THE INFORMATION MODE on page
16 to turn off the demo mode.
Next, stand on the foot rails of the treadmill. Locate the
clip attached to the key (see the drawing on page 10),
and slide the clip securely onto the waistband of your
clothes. Then, insert the key into the console. After a
moment, the displays will light. IMPORTANT: In an
emergency situation, the key can be pulled from
the console, causing the walking belt to slow to a
stop. Test the clip by carefully taking a few steps
backward; if the key is not pulled from the console,
adjust the position of the clip.
HOW TO USE THE MANUAL MODE
1. Insert the key into the console.
See HOW TO TURN ON THE POWER above.
2. Enter your weight if desired.
If you enter your weight
into the console, the con-
sole will display a more
accurate estimate of the
number of calories that
you burn. To enter your
weight, press the Your Weight increase and de-
crease buttons repeatedly. Note: Once you have
entered your weight, it will be saved in memory.
Reset
Position
11
3. Select the manual mode.
When you in-
sert the key,
the manual
mode will be
selected. If
you have se-
lected a pro-
gram, reselect the manual mode by pressing either
of the Programs buttons repeatedly until a track
appears in the upper half of the display.
4. Start the walking belt.
To start the walking belt, press the Start button, the
Speed increase button, or one of the speed but-
tons numbered 1 to 10.
If you press the Start
button or the Speed in-
crease button, the walk-
ing belt will begin to
move at 1 mph. As you
exercise, change the
speed of the walking belt as desired by pressing
the Speed increase and decrease buttons. Each
time you press a button, the speed setting will
change by 0.1 mph; if you hold down a button, the
speed setting will change in increments of 0.5 mph.
Note: After you press the buttons, it may take a mo-
ment for the walking belt to reach the selected speed
setting.
If you press one of the numbered buttons, the
walking belt will gradually change speed until it
reaches the selected speed setting. To select a
speed setting that includes a decimal—such as 3.5
mph—press two numbered buttons in succession.
For example, to select a speed setting of 3.5 mph,
press the 3 button and then immediately press the
5 button.
To stop the walking belt, press the Stop button.
The time will begin to flash in the display. To restart
the walking belt, press the Start button, the Speed
increase button, or one of the numbered buttons.
5. Change the incline of the treadmill as desired.
To change the incline of the treadmill, press the
Incline increase and decrease buttons. Each time
you press a button, the incline will change by 0.5%.
Note: After you press the buttons, it may take a
moment for the treadmill to reach the selected in-
cline setting.
Track