GE DBLR453ET Owner's Manual page 4

Read all safety information before using
4
intended purpose as described
in this Owner's Manual.
This dryer must be properly
installed and located in
accordance with the Installation
Instructions before it is used.
If you did not receive an
Installation Instructions sheet
with your dryer, you can obtain
one by calling, toll free, the GE
Answer Center", 800.626.2000.
Properly ground to conform
with all governing codes and
ordinances. Follow details in
Instructions.
Install or store where the tempera-
ture is above 50°F. (lO°C.). Do
not install the dryer where it will
be exposed to the weather.
– Connect to a properly rated,
protected and sized power supply
circuit to avoid elec~ical overload.
Gas dryers MUST be exhausted
to the outside. Carefully follow
the Exhausting details in the
Installation Instructions.
Exhausting electric dryers to
the outside is STRONGLY
RECOMMENDED to prevent
large amounts of moisture and
lint from being blown into the
room. Carefully follow the
Exhausting details in the
Installation Instructions.
1
not repair or replace
Do
recommended in this
Owner's Manual or in published
user-repair instructions that you
understand and have the skills
carry out.
to
appliance pull by the plug rather
than the cord to avoid damage to
the cord or junction of cord and
plug. Make sure that the cord
is located so that it will not be
stepped on, tripped over or
otherwise subjected to damage
or stress.