Unpacking; Service; Description - Bosch LTC 8714 Instruction Manual

LTC 8714 and 8715 Series | Instruction Manual | Unpacking
1

UNPACKING

Unpack carefully. This is electronic equipment and
should be handled carefully.
Check for the following items:
• Verify the model number of the unit.
• One (1) cable assembly with 9-pin D-sub
connectors.
If an item appears to have been damaged in shipment,
replace it properly in its carton and notify the shipper.
If any items are missing, notify your Bosch Security
Systems, Inc. Sales Representative or Customer

Service.

The shipping carton is the safest container in which the
unit may be transported. Save it for possible future use.
2 SERVICE
If the unit needs servicing, contact the nearest Bosch
Security Systems Service Center for authorization to
return and shipping instructions.
Service Centers
USA
Phone: 800-366-2283 or 717-735-6638
Fax: 800-366-1329 or 717-735-6639
CCTV Spare Parts
Phone: 800-894-5215 or 408-956-3853 or 3854
Fax: 408-957-3198
E-mail: BoschCCTVparts@ca.slr.com
Canada
Phone: 514-738-2434
Europe, Middle East & Asia Pacific Region
Phone: 32-1-440-0711
For additional information, see www.boschsecurity.com.
NOTE: Grounded wrist straps must be worn and
proper ESD safety precautions observed when
handling the electrostatic-sensitive printed circuit
boards.
WARNING: Electrostatic-sensitive
device. Use proper CMOS/
MOSFET handling precautions to
avoid electrostatic discharge.
Bosch Security Systems | May 23, 2005
3
This publication provides instructions for installing the
LTC 8714 Series and LTC 8715 Series Keyboard Port
Expanders in an Allegiant
switcher/controller system.
A single LTC 8714 Series unit can be used to interface
up to eight Allegiant Series keyboards with an
Allegiant system. A single LTC 8715 Series unit is used
to interface up to four (4) LTC 8714 Series expanders in
a system. Multiple LTC 8715 Series expanders can be
used along with multiple LTC 8714 Series expanders to
provide up to 64 keyboards in a system. The actual
number of units that can be used in a system depends
upon the model of the Allegiant system. The table
below lists the various Allegiant models and the
maximum number of keyboard expander units and
Allegiant Series keyboards that can be connected in a
system.
Allegiant System Capacities
Allegiant
Series
Model
LTC 8600
LTC 8800
LTC 8900
NOTE: The above table assumes 8 system keyboards
are connected directly into the Allegiant CPU bay
keyboard ports.
For each Allegiant Series keyboard used in an
"expanded configuration," one LTC 8557 Series
Keyboard Extension Kit (not included) is required.
Each keyboard port expander is supplied with a single
interface cable. This cable is used to connect the port
expander to either the Allegiant CPU bay or to
another port expander. The LTC 8557 Series Kit is
then used to connect the expanded keyboards to the
LTC 8714 Series Port Expander(s). See Typical
Application Diagrams found at the end of this manual.
ATTENTION
OBSERVE PRECAUTIONS
FOR HANDLING
ELECTROSTATIC
SENSITIVE
DEVICES

DESCRIPTION

®
Series matrix
Max Number Max Number
of Keyboards of LTC 8714
in System Supported
16 1
32 3
64 7
EN | 6
Max Number
of LTC 8715
Supported
0
1
3