Page 1
4XEM Camera Enclosure Mounting Instructions For IPCAMENCLOHF Mounting Configuration 1. Use the rear section of the Mounting Bracket (D) as a template for marking the position on the wall of the Mounting Holes (H). Remove and drill to pattern required.
Page 2
Fig. 2 – Fitting Instructions for camera 1. Heater (optional) 6. Cable Conduits (PGB11 x 2) 2. Heat Shield 7. Captive Retaining Screws x 4 3. Thermal Control Board 8. Heater & Blower Wires, Ground Wire 4. Camera Mounting Platform 9.
Page 3
Fitting Instructions for Camera 1. Unscrew the 4 captive Retaining Screws (C) and remove the Housing Cover (A) from the Housing Base (B). 2. Release the 4 Keyhole Screws (F) and then slide and withdraw the Camera Platform (G) from the Housing Base (B). 3.
Page 4
Wiring Instructions Figure 4 shows the internal wiring diagram of the IPCAMENCLOHF for the window demister. A spare 6 way terminal block is provided at the rear of the enclosure for the camera when required and for lens connections. Circuit identified as follows: •...