Auxiliary Function; Warning Indicators; Starting The Programme; Timer Follow-Up Indicator - Beko DRVT 71 W Installation And Operating Instructions Manual

Auxiliary function

Low temperature
This function allows for drying at lower
temperatures and therefore saves energy.
Warning LED will light up when you select
the function.
C
You must use this function when you
dry your synthetic or delicate laundry.

Warning indicators

C
Warning indicators may differ
according to the model of your
machine.
Filter cleaning
A warning LED will light up to remind filter
cleaning after the programme finishes.
C
If the filter cleaning warning LED
lights up continuously, please refer to,
"Solution suggestions for problems".

Starting the Programme

1. Press "Start/Pause/Cancel" button to
start the programme.
2. "Start/Pause/Cancel" button will light
up to indicate that the programme has
started.

Timer follow-up indicator

One of the LED lights will remain on as
far as programme runs and shows the
approximate remaining time.
C
LEDs on the timer follow-up indicator
will also flash when the child-proof lock
is activated.
Changing the programme after
the programme has started
You can use this feature to dry your
laundry in a different programme after
your machine has started to run.
For example;
Press and hold the "Start/Pause/Cancel"
button for about 3 seconds to select
"80" minutes programme instead of "60"
minutes programme
Select the "80" minutes programme by
rotating the program knob.
Press "Start/Pause/Cancel" button to
start the programme.
C
The programme which is selected
first will go on even if the programme
selection button is moved and another
programme mode is selected while the
machine is operating. You must cancel
the ongoing programme in order to
change the drying programme. (See,
Ending the program through canceling)
Adding/removing laundry in standby
mode
In order to add or take out laundry after
the start-up of the programme
1. Press the "Start/Pause/Cancel" button
to switch the machine to "Pause"
mode. Drying process will stop.
2. Open the door at Pause position and
close it again after adding or taking out
laundry.
3. Press "Start/Pause/Cancel" button to
start the programme.
C Any laundry added after the drying
process was started may cause the
already dried clothes in the machine
intermingle with wet cloth es and the
result will be wet laundry after the
drying process is over.
C Laundry may be added or taken
out as much as desired during a
drying process, but as this process
will interrupt drying continuously, it
will extend the programme duration
and increase energy consumption.
Therefore, it is recommended to add
laundry before the drying programme
is started.

Child-proof lock

There is a childproof lock to prevent
any programme interruption due to the
pressing of keys while the program is on.
The loading door and all keys except the
"On/Off" key on the panel are deactivated
when the child-proof lock is active.
In order to activate the childproof lock,
press the "Start/Pause/Cancel" and "Low
temperature" buttons simultaneously for
3 seconds.
To start a new programme after the
programme is over or to interrupt the
programme, the childproof lock should be
deactivated. To deactivate the childproof
lock, press the same buttons for 3 sec.
16 EN