Alpine RUE-4135 Owner's Manual

RUE-4135
Remote controller for
DVD navigation System
Owner's Manual
"
#
ENTER
MENU
/
$
%
A.PROC.
i
RETURN
& LO.PT.
(
POS.
2
)
5
~
8
+
, TEL.
0
ON/OFF
DEL.DEST.
-
V. SEL.

Map type Navigation Control Mode

1
Remote Control Transmitter
2
Status indicator
3
Joystick/ENTER Button
4
MODE Button
5
MENU Button
6
Button
7
VOICE Button
8
Numerick Keypad
9
M. PT./OK Button
!
DEL. DEST. Button
"
Zoom (Wide) Button
#
AUDIO/NAV. Button
$
Zoom (Detail) Button
%
RETURN/ Button
i
&
LO.PT. Button
(
POS. Button
)
ROUTE Button
~
-
+
TEL. Button
,
DEST./BS Button
-
Power ON/OFF Button
Arrow type Navigation Control
Mode
1
Remote Control Transmitter
2
Status indicator
3
Joystick/ENTER Button
4
MODE Button
5
MENU Button
6
-
7
VOICE Button
8
Numerick Keypad
9
M. PT./OK Button
!
DEL. DEST Button
"
-
#
AUDIO/NAV. Button
R
$
-
%
RETURN Button
&
LO.PT. Button
(
POS. Button
)
ROUTE Button
~
-
+
-
,
DEST./BS Button
-
Power ON/OFF Button

Head Unit Control Mode

1
Remote Control Transmitter
2
Status indicator
3
Radio mode: Preset Selection ( )
SEEK UP/DOWN (
CD/MD Player/Changer mode: PLAY/PAUSE (Push),
Disc Selection (
Music Sensor (
1
BW/FF (
Tape mode: PLAY/PAUSE (Push)
Programme Sensor (
2
4
MODE Button
5
SOURCE Button
3
6
BAND Button
4
7
-
8
-
5
9
(Display Angle Up) Button
!
-
"
6 Volume Up Button
#
AUDIO/NAV. Button
7
$
Volume Down Button
%
A.PROC. Button
&
MUTE Button
8
(
-
)
-
~
-
+
-
9
,
(Display Angle Down) Button
-
Power ON/OFF Button
!

AV Head Unit Control Mode

1
Remote Control Transmitter
2
Status indicator
3
Radio mode: Preset Selection ( )
SEEK UP/DOWN (
CD/MD Player/Changer mode:PLAY/PAUSE or Audio Mode (Push)
Disc Selection (
Music Sensor (
BW/FF (
Tape mode: PLAY/PAUSE (Push)
Programme Sensor (
4
MODE Button
5
SOURCE Button
6
BAND Button
7
-
8
Numerick Keypad
9
(Display Angle Up) Button
!
V.SEL. Button
"
Volume Up Button
#
AUDIO/NAV. Button
$
Volume Down Button
%
A.PROC. Button
&
MUTE Button
(
-
)
-
~
FUNC. Button
+
OP./CL. (Display Open/Close) Button
,
(Display Angle Down) Button
-
Power ON/OFF Button

Notes:

• Depending on the unit, some operations cannot be performed.
For details, see the Owner's Manual for the unit.
• After pressing the MODE button, press the following buttons
while the status indicator is blinking:
MAP type navigation: Numerick Keypad (0 to 9), BS button, OK button
Arrow type navigation: Numerick Keypad (0 to 9), BS button, OK button
Head Unit: (Display Angle Up) Button,
(Display Angle Down) Button
AV Head Unit: OP./CL. Button, (Display Angle Up) Button,
(Display Angle Down) Button

Installation of Remote Control Holder

L
• If direct sunlight reaches the remote control mounted on
the holder, remove the remote control from the holder and
put it in the glove compartment.
• If double-sided adhesive tape cannot install the holder
securely, use screws.
Note: Attach the blue protective paper side of double-sided
tape onto the console box, etc.

Handling Precautions

)
Do not drop or apply shock to the unit. It may get perma-
),
nently damaged.
),
Hold)
Keep the unit away from water and moisture, direct sun and
heat, and excessive dust.
), REW/FF ( )
Never use scouring pads, steel wool, abrasive powders or
harsh chemical agents, such as lye solution, for cleaning.

Battery Replacement

Applicable battery: Use two "AAA" sized dry batteries or equivalent.
1
Opening the battery cover.
Push on the cover and slide it as
indicated by the arrows then the
cover will be removed.
)

In Case of Difficulty

),
), Problem Cause
Hold)
Remote Reverse place-
Control ment of battery.
), REW/FF ( )
Inop-
Dead battery.
erative.
Remote Control
not pointed toward
the head unit.
ALPINE ELECTRONICS, INC.
Tokyo office: 1-1-8 Nishi Gotanda,
Shinagawa-ku, Tokyo 141-8501, Japan
Tel.: (03) 3494-1101
ALPINE ELECTRONICS OF AMERICA, INC.
19145 Gramercy Place, Torrance,
California 90501, U.S.A.
Tel.: 1-800-ALPINE-1 (1-800-257-4631)
ALPINE ELECTRONICS OF CANADA, INC.
Suite 203, 7300 Warden Ave. Markham,
Ontario L3R 9Z6, Canada
Tel.: 1-800-ALPINE-1 (1-800-257-4631)
Remote Control
Holder
Double-Sided
Adhesive Tape
(Before attaching
the tape, make
sure the mounting
locations are free
from dust or dirt)
Protective Paper
Clean with a soft, lint-free cloth or cotton swab slightly
dampened with a mild solution of detergent and water.
Do not operate this unit in a manner that could distract you
from driving safety.
2
Replacing the batteries.
Remove the old batteries. Insert new ones
matching the (+) and (–) polarities as shown
in the diagram inside the remote control.

Specifications

Solution
Battery Type ................................................... AAA size batteries
Place the battery correctly into
Battery Quantity ......................................................................... 2
its cradle in the compartment.
Dimensions (W × H × D) ................................. 51 × 36 × 118 mm
Replace the battery with a new
one.
Point the remote control
Weight (without battery) ......................................... 60 gr (2.1 oz)
directly toward your head unit.
R
ALPINE ELECTRONICS OF AUSTRALIA PTY. LTD.
6-8 Fiveways Boulevarde Keysborough,
Victoria 3173, Australia
Tel.: (03) 9769-0000
ALPINE ELECTRONICS GmbH
Kreuzerkamp 7-11 40878 Ratingen,
Germany
Tel.: 02102-45 50
ALPINE ITALIA S.p.A.
Via C. Colombo 8, 20090 Trezzano Sul
Naviglio MI, Italy
Tel.: 02-48 47 81
Remote
Control
Reinforcing Screws
Console Box etc.
3
Closing the cover.
Push the cover in the arrow direction
until a click is heard.
(2 × 1-13/32" × 4-21/32")
ALPINE ELECTRONICS FRANCE S.A.R.L.
(RCS PONTOISE B 338 101 280)
98, Rue De La Belle Etoile, Z.I. Paris Nord Il
B.P. 50016 F-95945, Roissy,
Charles De Gaulle Cedex, France
Tel.: 01-48 63 89 89
ALPINE ELECTRONICS OF U.K., LTD.
13 Tanners Drive, Blakelands,
Milton Keynes MK14 5BU, U.K.
Tel.: 01908-61 15 56
ALPINE ELECTRONICS DE ESPAÑA, S.A.
Portal De Gamarra 36, Pabellón 32
01013 Vitoria (Alava)-Apdo. 133, Spain
Tel.: 34-45-283588
68P20877Y65-O
Printed in China (Y)