Diamond Multimedia Viper V770 User Manual page 15

9. Click Finish, then click Close.
10. Click Close to exit the Display Properties dialog.
11. Reboot your computer.
Windows NT 4.0 Manual Driver Installation
To install the NT 4.0 driver for your Diamond graphics accelerator, go to
Start > Settings > Control Panel > Display. The Display Properties
page appears. Continue with the following procedure:
1. Click the Settings tab, then click the Display Type... button.
2. Click the Change button. The Change Display dialog appears.
3. Click Have Disk... The Install From Disk dialog appears.
4. Insert the installation CD. If your system is set to "auto-play," the
Diamond installation program opens. Click Quit to exit the program.
5. Type X:\NT4\English\Drivers (where "X" is the letter of your CD- or
DVD-ROM drive). Click OK. The Change Display dialog appears.
6. Select the driver for your Diamond product and click OK.
7. If the Third-party Drivers window appears, click Yes to proceed. The
driver files will now be copied to your system.
8. After you receive a message that the drivers were successfully installed,
click OK.
9. Click Close in the Display Type dialog. You are now placed back into
the Display Properties page.
10. Click the Test button to check your settings, or, click the close
window box in the upper-right corner of the Display Properties page to
exit.
11. Reboot your computer.
After you reboot, you may be requested by the system to check the display
driver. Make any changes you want to your display settings at this time.
11