Iomega Zip drive 100 Installation Manual page 13

Installing Iomega Software under Windows NT 3.51:
Run a:\setupnt.exe from the Windows NT Install diskette.
1.
•
If the SetupNT program is unable to locate the "tools" disk, make
sure it is fully inserted and click "OK." If SetupNT is still unable to
locate the "tools" disk, click "OK" again and SetupNT will
automatically run the "Windows NT Setup" program so that you can
install the Iomega Zip IDE/ATAPI driver. Continue to step 2.
•
If the necessary driver is already present on the system, SetupNT
will be able to locate the "tools" disk and install ToolsNT software.
After Windows NT reboots, the Zip ATAPI drive will be ready to use.
2. From the Windows NT Setup window, choose the Options pull-down
menu and select "Add/Remove SCSI adapters."
NOTE: Windows NT installs drives or adapters that use the IDE
interface as SCSI adapters.
3. When the list of adapters appears, click "Add," then click "OK" in the
message box.
4. Click the down arrow next to the window for "Select SCSI Adapter
Option" to open the adapter list.
5. Scroll down the list of adapters and select the Iomega Zip IDE /
ATAPI driver.
6. Click the "Install" button.
7. Choose "Current" in the Windows NT dialog box. Windows NT
will then add the necessary driver to the list of installed adapters
found by the operating system.
8. Click the "Close" button and exit Windows NT Setup.
9. Click "OK" and reboot the system. Remove the Install diskette from
the floppy drive while Windows NT reboots.
10. After Windows NT reboots, run SetupNT again from the Install
diskette to install the ToolsNT software package.
IMPORTANT! If the SetupNT program still cannot locate the
"tools" disk, refer to the NTReadme.txt file on the Install diskette for
instructions on manually installing the driver.
11