Advertisement
IMPORTANT SAFETY INSTRUCTIONS
1). Read & Retain these Instructions carefully before installing or operating this product.
2). Comply with Warnings: All warnings and instructions for these products should be adhered to.
3). Unpacking: On unpacking your product please check carefully for any signs of damage that may have occured whilst in transit from the Laney factory to your dealer. In the unlikely
event that there has been damage, please repack your unit in it original carton and consult your dealer. We strongly advise you to keep your original transit carton, since in the unlikly
event that your unit should develop a fault, you will be able to return it to you dealer for rectification securely packed.
4). Amplifier Connection: In order to avoid damage , it is advisable to establish and follow a pattern for turning on and off your system. With all system parts connected, turn on
source equipment, tape decks, cd players, mixers, effects processors etc, BEFORE turing on your guitar amplifier. Many products have large transient surges at turn on and off which can
cause damage to your speakers.
By turning on your guitar amplifier LAST and making sure its level control is set to a minimum, any transients from other equipment should not reach your loud speakers. Wait till all
system parts have stabillised, usually a couple of seconds. Similarly when turning off your system always turn down the level controls on your guitar amplifier and then turn off its power
before turning off other equipment
5). Cables: Never use shielded or microphone cable for any speaker connections as this will not be stubstantial enough to handle the amplifier load and could cause damage to your
complete system.
6). Caution: These professional loudspeaker systems are capable of generating very high sound pressure levels. Use care with placement and operation to avoid excessive levels that
can cause permament hearing damage.
7). Exposure to extremely high noise levels may cause a permanent hearing loss. Individuals vary considerably in
susceptibility to noise induced hearing loss, but nearly everyone will lose some hearing if exposed to sufficiently
intense noise for a sufficient time. The U.S. Government's Occupational Safety and Health Administration (OSHA)
has specified the permissible noise level exposure in the chart oposite.
According to OSHA, any exposure in excess of the above permissible limits could result in some hearing loss. Ear
plugs or protectors in the ear canals or over the ears must be worn when operating this amplification system in
order to prevent a permanent hearing loss if exposure exceeds the limits set forth oposite. To ensure against
potentially dangerous exposure to high sound pressure levels it is recommended that all persons exposed to
equipment capable of producing high sound pressure levels such as this amplification system be protected by hearing
protectors while this unit is in operation.
8). Servicing: The user should not attempt to service these products. Refer all servicing to qualified service
personnel
In order to reduce environmental damage, at the end of its useful life, this product must not be disposed of along with normal
household waste to landfill sites. It must be taken to an approved recycling centre according to the recommendations of the WEEE
(Waste Electrical and Electronic Equipment) directive applicable in your country.
This product conforms to the requirements of the following European Regulations, Directives & Rules:-
CE Mark (93/68/EEC), Low Voltage (72/23/EEC), EMC (93/68/EEC),
RoHS (EU2002/95/EC), WEEE (EU2002/96/EC)
Laney
Duration Per Day
Sound Level dBA,
In Hours
slow response
8
90
6
92
4
95
3
97
2
100
102
1 ½
105
1
110
½
Page 7/8
Advertisement
