Advertisement
MINI
IMPORTANT SAFETY INSTRUCTIONS
1). Read & Retain these Instructions carefully before installing or operating this product.
2). Comply with Warnings: All warnings and instructions for these products should be adhered
to.
3). Unpacking: On unpacking your product please check carefully for any signs of damage that
may have occurred whilst in transit from the Laney factory to your dealer. In the unlikely event that
there has been damage, please repack your unit in its original carton and consult your dealer.
We strongly advise you to keep your original transit carton, since in the unlikely event that your
unit should develop a fault, you will be able to return it to your dealer for rectification securely
packed.
4). Amplifier Connection: In order to avoid damage, it is advisable to establish and follow a
pattern for turning on and off your system. With all system parts connected, turn on source
equipment, CD/MP3 players, mixers/recorders, etc, BEFORE turning on your guitar amplifier.
Many products have large transient surges at turn on and off which can cause damage to your
speakers. By turning on your guitar amplifier LAST and making sure its level control is set to a
minimum, any transients from other equipment should not reach your loud speakers. Wait till all
system parts have stabilised, usually a couple of seconds. Similarly when turning off your system
always turn down the level controls on your guitar amplifier and then turn off its power before
turning off other equipment.
5). Servicing: Refer all servicing to qualified service personnel. Servicing is required when the ap-
paratus has been damaged in any way, such as when the DC Power Supply is damaged, liquid
has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to
rain or moisture, does not operate normally, or has been dropped.
6).Placement: This electrical apparatus should not be exposed to dripping or splashing and care
should be taken not to place objects containing liquids, such as vases, upon the apparatus.
Do not install near any heat sources such as radiators, heat registers, stoves or other apparatus
(including amplifiers) that produce heat. Do not block any of the ventilation openings.
7). When using the DC power Supply: Only use the approved DC power supply (available sepa-
rately).
Protect the power cord on the DC power Supply from being walked on or pinched, particularly at
plugs, convenience receptacles, and the point they exit from the apparatus.(See notes on using
the DC Power Supply page 11).
8). Batteries: Use alkaline or NiMH batteries in the product. (See notes on fitting and replacing
batteries page 10).
USER MANUAL
www.laney.co.uk
2
Advertisement
