Dell Precision Workstation 360 Setup And Quick Reference Manual page 29

Power Light Hard-Drive
Light
Blinking yellow Solid green
Solid green and a N/A
beep code during
POST
Solid green power N/A
light and no beep
code and no video
during POST
Solid green power N/A
light and no beep
code, but the
computer locks
up during POST
Problem Description
A system board or VRM failure has
occurred.
A problem was detected while the
BIOS was executing.
The monitor or the graphics card
may be faulty or incorrectly
installed.
An integrated system board device
may be faulty.
Suggested Resolution
Check the diagnostic lights to see
if the specific problem is identified.
See "System Board Problems" in
your User's Guide.
See "Beep Codes" in your User's
Guide. Also, check the diagnostic
lights to see if the specific problem
is identified.
Check the diagnostic lights to see
if the specific problem is identified.
See "Video and Monitor Problems"
in your User's Guide.
Check the diagnostic lights to see
if the specific problem is identified.
If the problem is not identified,
contact Dell for technical
assistance.
Setup and Quick Re ference Guide
29