Preventive Maintenance - Hotel Fitness Tr9800 Treadmill Manual

PREVENTIVE MAINTENANCE

Regular maintenance is necessary for optimal perfor-
mance and long life of the treadmill. Please read and
follow all instructions below. If the treadmill is not
maintained as described, components may wear
excessively, the treadmill may be damaged, and
the warranty will be voided. If you have questions
about maintenance, please see the back cover of this
manual. CAUTION: Make sure to remove the key
and unplug the power cord before performing any
maintenance procedures.
WEEKLY MAINTENANCE
1. Unplug the power cord. Inspect and properly
tighten all external parts of the treadmill.
2. Apply a mild multi-purpose cleaner to a 100 per-
cent cotton cloth and remove any dust and grime
from the handrails, upright, foot rails, frame, and
motor hood. In addition, wipe the walking platform
along the sides of the walking belt. Do not wipe
under the walking belt. Apply a small amount of
mild multi-purpose cleaner to a 100 percent cotton
cloth and wipe the console and the screens. Do not
spray cleaner directly onto the treadmill or use
ammonia or acid-based cleaners.
3. Make sure that the walking belt is centered and
properly tightened. If it is centered and runs
smoothly, do not make any adjustments. If the walk-
ing belt needs to be adjusted, see page 35.
MONTHLY MAINTENANCE
1. Unplug the power cord. Remove the four 5/16"
x 1/2" Screws (16) attaching the Motor Hood (66),
and lift off the Motor Hood.
1
16
66
16
2. Using a hand-held vacuum, clean the area under
the Motor Hood (not shown). Be careful to avoid
touching any components. Check the Motor Belt
(57) for wear and cracks. If the Motor Belt needs to
be replaced, see the back cover of this manual.
2
3. Plug in the power cord and insert the key into the
console. Press the Start/Stop button. Be careful
to avoid injury; keep your hands away from
moving parts and make sure that your clothes
cannot become caught in moving parts. While
the walking belt is moving, check the treadmill for
unusual noises or odors. If any of these problems
exists, see the back cover of this manual. Remove
the key and unplug the power cord. See step 1.
Reattach the Motor Hood (66) with the 5/16" x 1/2"
Screws (16).
16
29
57