Epic 790 Hr Elliptical User Manual page 9

9. Identify the Left Handlebar (8) and the Left Upper Body
Arm (11), which are marked with "Left" stickers.
Orient the Left Handlebar (8) and the Left Upper Body
Arm (11) as shown. Insert the Left Handlebar into the
Left Upper Body Arm. Attach the Left Handlebar with
two M8 x 41mm Button Bolts (78) and two M8
Jamnuts (79). Make sure that the Jamnuts are in
the hexagonal holes in the Left Upper Body Arm.
Attach the Right Handlebar (9) to the Right Upper
Body Arm (12) in the same way.
10. Apply a generous amount of the included grease to the
Pivot Axle (74). Then, apply grease to two Wave
Washers (111).
Insert the Pivot Axle (74) into the Upright (3) and center
it. Orient the Left Upper Body Arm (11) as shown, and
slide it onto the left end of the Pivot Axle. Slide the
Right Upper Body Arm (12) onto the right end of the
Pivot Axle.
Tighten an M8 x 23mm Button Screw (84) with an M8
Washer (88) and a Wave Washer (111) into each end
of the Pivot Axle (74). Make sure that the Wave
Washers are on the ends of the Pivot Axle.
9
79
Hexagonal
Holes
11
10
Grease
74
88
11
111
84
9
9
8
79
78
78
12
88 84
3
Grease
12
111