Screen Settings - Sony FWD42B2/DS Operating Instructions Manual

Screen Settings

For the setting method, see "Overview of the Menus" (page 22).
Note
If no signal is being input, "Aspect" and "Adjust Screen" cannot be set.
Menu
Multi Display
Multi Display
Off
2×2
3×3
4×4
1×2
1×3
1×4
2×1
3×1
4×1
Position
Output Format
Tiles
Window
LED
26
GB
Function and operation
Allows you to make settings for connecting multiple displays to form a video wall.
Notes
• During video input, "Multi Display" displays a picture as close as possible to the
current "Aspect" setting. But during PC input, it displays with "Aspect" set to "Full
2".
• When "Position" is set to the right-bottom, the 1 indicator lights up even if "LED" is
set to "Off". The indicator also lights up even when the display is off (standby), errors
are detected, or the display is in sleep mode including the case of no signal or
unsupported signal.
• "Multi Display" function cannot be used for 480i, 576i,1080/50i, 1080/60i or 1080/
24psf signal.
Do settings to form a video wall.
Uses a single screen.
Settings to connect 2, 3 or 4 displays both vertically and horizontally.
Settings to connect 2, 3 or 4 displays horizontally.
Settings to connect 2, 3 or 4 displays vertically.
Settings for the screen position of each display.
You can select a picture output format. The picture position is automatically adjusted,
and you can get a suitable picture output.
Shows full signal on each screen.
Shows one large picture with multi display naturally. Part of the signal will go behind the
bezel area.
Select "On" or "Off". If you select "On", the 1 indicator on the front panel (page 10) to
be continually turned on.