Before Operation; Precautions; Battery Information Of Remote Control - Pyle PL78DLB Instruction Manual

7" single-din in-dash motorized touch screen lcd monitor w/dvd/cd/mp3/mp4/usb/sd/am-fm & bluetooth wireless streaming
Table of Contents

Advertisement

6. Trouble Shooting
Please read the user manual carefully before using the this player. If you have any troubles
in using this player, try to solve the problems by the suggestions mentioned below. If you can
not remove the trouble after using all the suggestions, please contact the company or the
technical service centre authorized by us. For the sake of your safety, please do not open the
cover and repair the player by yourself, if that, it may cause electric shock.
NO PICTURE, SOUND AND INDICATION
* Ensure that the power cord is not damaged or the fuse is not blown.
NO SOUND BUT HAVE PICTURE
* Ensure that the player's audio output has a good connection .
* Check whether you have turned down the volume.
* Ensure that you have set the right AUDIO setup of the player.
* Ensure that the audio is not under mute.
NO PICTURE BUT HAVE SOUND
* Ensure that the player's video output has a good connection with monitor's video input.
* Check whether the video connector is damaged.
* Ensure that you have set the right VIDEO settings of the player.
FLAWS OF PICTURE OR SOUND
* Check whether the setting of AUDIO is right.
REMOTE CONTROL IS INSENSITIVE OR DOES NOT WORK
* Check the batteries of remote control and make sure that they are to be powerful and
good conductivity.
* Direct the remote control to the IR sensor of the player.
* Check whether there are some obstacles between the remote control and IR sensor.
SOME FUNCTION BUTTONS DO NOT WORK
* Turn off the power, then turn on again.
* Reset the unit to zero, then turn on again.
* Remove the front panel from the unit, then install it again and then turn on again.
THE RADIO DOES NOT WORK
* Check whether the antenna cable is connected firmly. Or manually tune for a station.
THE TFT DISPLAY LOST TOUCH EFFECT
*
In any mode, press the MENU on the remote to turn to the main interface, then press SET on the
remote to turn to setting mode then press right arrow to select calibrate mode and then tap the
cross cursor as it show.
PDF created with FinePrint pdfFactory trial version
http://www.pdffactory.com

1. Before Operation

1.1 Precautions

1. Read through this instruction manual before installation and use.
2. Clear the panel and case with soft dry cloth only, do not apply any
kind of thinner, alcohol or sprays.
3. The apparatus shall not be exposed to dripping or splashing .
1.2 Battery Information of the Remote Control
Replace Battery in the Remote Control
Fig.1
Fig.2
1.Before using the remote control for the first time, pull the insulating
sheet out of the remote control as the direction indicated by the
arrow.(see fig.1)
2.Press the movable block hold as the direction indicated by the A arrow
(See fig.2), then pull the battery holder out of the remote control as
the direction indicated by the B arrow(see fig.2).
3.Replace the old battery by a new battery with (+) polarity side upward.
(See fig.3).
4.Insert the battery holder to the original position in remote control.
(See fig.3).
Note about the Battery of the Remote Control
1.
Improper use of battery may cause overheating or explosion. so that
Result in injury or fire .
2.Battery leakage may cause damage to the remote control(Battery
Life: 6 months with normal use in normal room temperature).
3.Do not short the battery.
4.Do not throw the battery into the fire.
5.To avoid the risk of accident, keep the battery out of reach of children.
:
+ side up
B
A
Fig.3
:

Advertisement

Table of Contents
loading

Table of Contents