Radio Operation - Boss Audio Systems BV6820 User Manual

3.

Radio Operation

1. FREQUENCY SELECT
In RADIO mode. Press and hold the SEL button repeatedly to select your desired frequency
EUROPE,USA1 ,USA2,JAPAN,RUSSIA.
2. BAND BUTTON
Press the BAND button on the front panel to select your desired radio band of FM1, FM2,
FM3,AM1 and AM2, and the selected band will be displayed on the monitor of the front panel.
3. TUNE/SEEK UP/DOWN BUTTONS
1) Press and hold the >>|/|<< button to automatically search up/down for a available station
from the current frequency.
2) Briefly press the >>|/|<< to manually search up or down with step by step for your desired
station from the current frequency.
4. APS BUTTON
In RADIO mode:
1) When pressing and holding the APS button ,the radio searches from the lowest frequency
and checks the signal strength level until 1 cycle search is finished. And then the 6 strongest
stations are preset to the corresponding preset number memory bank. The AS operation
is implemented in each bank of the selected band. When the AS operation is finished,
it will resume broadcasting
on the M1.(It can store 3x6 stations for FM and 2x6 stations for AM in all)
2) When pressing the APS button briefly the radio searches for each preset station from the M1.
When the field strength level is more than the threshold level of the stop level, the radio
holds at that preset number for few seconds with releasing mute, and then searches again.
After finishing a circle of searching, it will stop searching on the M1.
NOTE: In FM band, FM1,FM2,FM3 is checked one at a time.
In AM band, AM1, AM2 is checked one at a time.
5. PRESET STATION [ 1-6 ] BUTTONS
1) To memorize the current frequency on the current band, press and hold any one of the six
Number buttons (1-6) .
2) To recall the memory station on the current band, press one of the Number buttons [1-6] .
6. STEREO/MONO BUTTON
Press the ST button on the remote control to select the STEREO or MONO sound mode for
FM band.
7. LOC BUTTON
1) When the signal of distant radio stations are very weak and the receiving effect is bad
during tuning, check whether there is the word LOC on LCD. If there is the word LOC on LCD,
press this button to turn off the LOC function, then tune again for the distance radio station;
2) When the signals from the local radio stations are too strong, this could lead to interference.
press this button to turn on the LOC function, and the LOC icon will be lit up on the LCD.
Re-tune for the local station required.
*Note: In FM mode, Repeatedly press the SEL button on the unit also can select the ST ON
/OFF, LOC ON/OFF MODE