Subscribe to Our Youtube Channel
Related Manuals for Teac DM-3200
Summary of Contents for Teac DM-3200
- Page 1 DM-3200 Pro Tools DM-3200 DAW Control HUI emulation for Pro Tools Version 1.11 DM-3200 Pro Tools...
-
Page 2: Table Of Contents
DM-3200 Pro Tools Summary ................................3 Setting up the DM-3200 ..........................3 Setting up Pro Tools ............................3 LCD Screen................................4 Switching between Ch1-8 and 9-16 screens....................4 Channel strips................................. 5 Encoder ................................5 Ring LED 15-dot display ..........................5 Rec function .............................. -
Page 3: Summary
From the Setups menu in Pro Tools, select Peripherals and click on the MIDI Controllers tab. Select a HUI device for #1 and #2. Assign the MIDI Receive and Send of #1 to the DM-3200’s Port 5. Similarly, assign the MIDI Receive and Send of #2 to the DM-3200’s Port 6. It should look like the screen below. -
Page 4: Lcd Screen
DM-3200 Pro Tools 2. LCD Screen The HUI Emulate LCD screen looks like this: 2.1 Switching between Ch1-8 and 9-16 screens The HUI emulate screen is switched on a 8-channel basis. Switching between the channels 1-8 and 9-16 are made as follows: Switching at the REMOTE screen Select the target channel's HUI emulate screen using CONTROL under the Pull-up menu. -
Page 5: Channel Strips
Information displayed here comes in messages sent by Pro Tools. 3.2 Ring LED 15-dot display While the Ring LED of the DM-3200 is made up of an array of 15 dots, HUI uses a 12-dot system. Relationships between the two are as shown below:... -
Page 6: Rec Function
DM-3200 Pro Tools 3.3 Rec function This is controlled by holding the REC key while pressing the SEL key on/off on an individual module. The LEDs turn on or off depending on messages sent by Pro Tools. 3.4 Solo and Mute keys These are controlled by switching the keys on/off on the individual channels. -
Page 7: Lcd
DM-3200 Pro Tools 4.1 LCD Control target parameters are displayed in the Select assign section. The name of each channel, information on grouping, Input/Output sources, etc, are displayed in the Channel Name section. Those displays depend on the response from DAW. -
Page 8: Transport
DM-3200 Pro Tools 5. Transport Control target parameters are as follows: DM-3200 Pro Tools function Note Transport keys Transport Controls the transport: Rewind, Fast Forward, Stop, Play, and Record. Shift + Record Quick Punch Enables Quick punch mode. < Bank, Bank >...
Need help?
Do you have a question about the DM-3200 and is the answer not in the manual?
Questions and answers