Pyle PDCD204 User Manual page 5

Drive unit
(20) CD compartment 2
This is the compartment (disc 2 drive) in which the CD is placed.
(21) OPEN/CLOSE button for CD compartment 2
You can open and close the CD compartment of the DISC 2 drive with this button.
The CD compartment cannot be opened with the CD player in playback mode.
(22) CD compartment 1
This is the compartment (DISC 1 drive) in which the CD is placed.
(23) OPEN/CLOSE button for CD compartment 1
You can open and close the CD compartment for the DISC 1 driver with this button.
The CD compartment cannot be opened with the CD player in playback mode.
(24) ON/OFF "POWER" switch
The dual CD player is switched on and off with this mains switch. The appliance is switched on after
pressing the switch. The power indicator above the switch goes on.
(25) System connection socket
Connect this socket to terminal (19) on the control unit with the supplied system control cable.
(26) "AC INPUT" mains connection
The supplied mains cable for the power supply of the appliance is plugged in here.
(27) AUDIO – OUT R&L sockets
The right and left audio signals of CD player 2 are output in analogue form at these cinch sockets. Connect
the audio input of your mixer or amplifier here.
Red cinch socket = right output
White cinch socket = left output
(28)FUSE Socket
LC display
(A) – (D) Track, minutes, seconds, frame display and display of additional information
The current CD data, such as position and time, is displayed here.
In addition the following messages can be displayed:
"OPEN" = CD compartment is opened
"CLOSE" = CD compartment is closed
"no disc" = no CD inserted or inserted CD cannot be read
"Read" = CD is currently being read
(E) Bar graph display
The temporal status is displayed in "bar form" here in addition to the digital time display. The display
depends on which display mode has been set (remaining track time, total remaining time or elapsed track
time). The bar display starts to flash 15 seconds before the end of the track.
(F) SINGLE
This symbol appears after selecting single track playback mode.
(G) PITCH display
The current BPM (beats per minute) change is displayed here. The BPM change depends on the PITCH
side control setting.
(H) REMAIN
The remaining time of the current track is displayed if this symbol is
8. Setting up / Rack installation of the device
The dual CD player is suitable for table top use or for the installation in a 19" (483mm) rack.
Make sure the appliance is well ventilated when installing it together with other equipment.
Do not place the appliance on soft surfaces, such as carpets or beds. Furthermore the air
circulation may not be obstructed by objects such as magazines, table cloths or curtains.
This prevents heat from being dissipated from the appliance and can result in overheating
(risk of fire!). If the appliance is installed in a rack, an additional fan may be necessary to
dissipate the heat generated in the rack.
Do not drill any holes or screw any screws into the housing in order to attach the appliance,
since this can damage it and impair its safety.
Make sure the appliance is in a stable position on a stable surface. The appliance can injure
persons by falling down or overturning.
Only operate the drive unit of the CD player in a horizontal position, since it will not work
properly otherwise. Non-observance of these instructions can result in the inserted CD or
the drive unit becoming damaged.
9
lit up.
10