Advertisement
Charging the Battery:
You can charge the built-in rechargeable battery with the included mini-USB cable. To
charge the battery, the master switch must be in the "OFF" position. A red LED will light up
when the unit is on charging and will go out once the battery is fully charged. If the alarm
clock of battery become extremely hot while charging, please disconnect it immediately.
When the battery is low, the blue LED will keep flashing or the screen display will be unclear.
Please charge it immediately. If the battery dies, the current video or audio file will be
recorded to the microSD card automatically prior to power down.
Adjust DVR Time/Date:
The time and date of your alarm clock DVR can be configured by the following steps.
1 – Install the driver "SPCA1520_V1200_WHQL.exe" in the included CD.
2 – Turn off the camera and take out the microSD card, then connect the clock to the PC
via the mini USB cable. Once the drivers have been installed, you will be able to use the
clock in Webcam mode.
3 – Run "SyncTime.exe" then click "Synchronization". Now the recordings will show the
same time as your PC.
Specifications:
Image Sensor
Resolution
Video Format
Frame number
Viewable angle
Motion Detection
Minimum illumination
Battery capacity
Continuous recording time
Remote operating distance
Range for sound recording
Power consumption
Storage temperature
Operating temperature
Operating humidity
Type of memory card
Capacity of memory card
Player software
USB Interface
Operating system
Recording Usage
Charging time
2.0 MegaPixel
640x480
AVI
30fps
72
6 meters distance (straight line)
1LUX
2200MA
Up to 12 hours
15m
Approx 40m2
130MA / 3.7V
-20~80 ℃
-10~60 ℃
15~85% RH
Micro SD card
32GB maximum
Windows Media player / KM player
USB1.1/2.0
WIN 2000/ XP / Vista32 / 7
Approx 1GB/40 minutes
Approx 4 hours
Advertisement
