Advertisement
Clock Operation Instructions:
The Alarm Clock function of this DVR functions like most alarm clocks. There are 5
buttons on the alarm clock that will control the basic clock and alarm functions: HR, MIN,
SET, LIGHT and TALK/SNOOZE. The clock can be set to display in 12 or 24 hour formats
("HR" button) and can alarm in 5 different ring tones ("MIN" button). During normal
operation the clock can also read off the current time to you in English (top button). The
"LIGHT" button will turn on or off the backlight of the LCD.
Initial Setup:
1 – Remove the back battery panel from the remote control.
2 – Remove the clear battery protector strip from the end of the battery. This strip is
placed to prevent the battery from discharging completely during shipping, and damaging
the battery.
3 – Once the protective strip is removed, the remote control will be ready for use.
Time/Alarm/Chime Configuration:
Press the "SET" button to cycle through the configuration of time, alarm and chime setting
modes. Continue pressing the button until you have selected the mode that you wish to
configure.
Setting Time:
Once you have selected the Time setup mode using the "SET" button from above, now
you can press the "HR" and "MIN" buttons to change the hour and minute of the current
time.
Setting Alarm:
Once you have selected the Alarm setup mode using the "SET" button again until the
symbol appears. Now you can press the "HR" and "MIN" buttons to set the time for the
alarm to sound. When the alarm is going off, pressing the top button on the clock will
snooze the alarm for 10 minutes before it starts up again (up to 6 times.)
Activating/Deactivating Alarm and Chime:
Pressing the "SET" button again after setting the Alarm time above will show
This will allow you to configure the status of both the alarm and the hourly chime.
Pressing the "HR" button will turn on or off the alarm
Pressing the "MIN" button will turn on or off the hourly chime.
Advertisement
