Adjusting The Rocking Thread Take-Up - JUKI MF-7524 Instruction Manual

2. Adjusting the rocking thread take-up

WARNING :
To protect against possible personal injury due to abrupt start of the machine, be sure to start the
following work after turning the power off and ascertaining that the motor is at rest.
❷
1) Loosen setscrews ❶, move rocking thread take-up ❷
to the right and left, adjust so that 90 mm is given from
❶
the thread hole to the center of rocking thread take-up
shaft ❸, and fix setscrews ❶ as shown in the figure.
2) Adjust rocking thread take-up base ❹ so that it is
❸
positioned horizontally when the rocking thread take-
up is in its lowest point, and fix it with screw ❺.
❺
– 16 –