Gary Fisher Cronos Service Information page 17

To install the bearings
1. Apply a liberal coat of grease to the contact surfaces of one bearing and the drive side
of the bottom bracket shell (Figure 30).
2. Slide a bearing onto the installation tool.
+ Either side of the bearing is the "right side."
3. Press one bearing into the drive side of the bottom bracket shell (Figure 31).
+ To remove the installation tool, press the release tab.
4. Repeat steps 1-3 for the other bearing on the non-drive side.
17 |
GARY FISHER SERVICE INFORMATION
figure 30. Greasing the bearing and the frame seat
figure 31. Pressing the bearing into the frame