Battery Replacement - Garrett Infinium LS Owner's Manual

Figure 17
To access the battery pack, unscrew the battery
cap at the rear of the detector housing by hand; DO
NOT use tools. The o-ring should remain in the con-
trol housing while the battery pack slides out. When
installing batteries ensure that they are aligned with
the correct polarity (plus and minus) markings. Re-
install the battery pack by placing the contact end
of the housing inside first and pointing downwards.
(Figure 17.) Verify that the o-ring is well-lubricated
and free from debris. Add a little silicon grease or
petroleum jelly if necessary. Re-install the battery cap,
hand tightening it until it is flush with the housing and
the two index marks are aligned as shown. DO NOT
over rotate. (Figure 18.)
BATTERY REPLACEMENT
Figure 18