Rear Panel Connections - Harman Kardon HS 250 Owner's Manual

Rear Panel Connections

Composite Video Output
S-Video Output
Component Video Outputs
Scart TV Output
AC Power Cord
FM Antenna
Audio In
Composite Video Output: Connect this
jack to the video input on a television or video
projector.
S-Video Output: Connect this jack to the
S-Video input on a television or video projector.
Component Video Outputs: These out-
puts carry the component video signals for
connection to display monitors with component
video inputs. For standard analog TV's or
projectors with inputs marked Y/Pr/Pb or
Y/Cr/Cb, connect these outputs to the correspon-
ding inputs. If you have a high-definition televi-
sion or projector that is compatible with high
scan rate progressive video, connect these jacks
to the "HD Component" inputs. Note that if you
are using a progressive scan display device, then
"Progressive" must be selected in the Video Set-
up Menu in order to take advantage of the
progressive scan circuitry. See page 20 for more
information on progressive scan video.
IMPORTANT: These jacks should NOT be con-
nected to standard composite video inputs.
SCART OUT (TV): If your TV has a SCART
socket, you can connect a SCART cable to your
TV and to your DVD Player for improved video
quality. The SCART cable carries both audio and
video. You can select Composite Video or RGB
video for that SCART connector's video output
signal.
Subwoofer Output
Coaxial Digital Input
Optical Digital Input
Analog Audio Outputs
Front Speaker Outputs
Remote IR Input
TV Audio In
AC Power Cord: Connect this plug to an
AC outlet. If the outlet is controlled by a switch,
make certain that it is in the ON position.
FM Antenna: Connect to the supplied FM
antenna.
Audio In: Connect to a line-level analog
audio source: TV, tape player, Minidisc, PC, etc.
Subwoofer Output: Connect to the
SUB/LFE input on the subwoofer.
Coaxial Digital Input: Connect the coax
digital output from a DVD player, HDTV receiver,
LD player, MD player, satellite receiver or CD
player to this jack. The signal may be either a
Dolby Digital signal, DTS signal or a standard
PCM digital source. Do not connect the RF digi-
tal output of an LD player to these jacks.
Optical Digital Input: Connect the optical
digital output from a DVD player, HDTV receiver,
LD player, MD player, satellite receiver or CD
player to this jack. The signal may be either a
Dolby Digital signal, DTS signal or a standard
PCM digital source.
Analog Audio Outputs: Connect these
jacks to the analog audio input on a TV set or
external audio system for analog audio playback
or to the RECORD/INPUT jacks of an audio
recorder for recording.
Coaxial Digital Output
Subwoofer Trigger Output
USB On-The-Go Input
HDMI Output
Remote IR Output
DMP Connector
Front Speaker Outputs: Connect these
outputs to the matching + or – terminals on
your left and right speakers. In conformance with
the new CEA color code specification, the White
terminal is the positive, or "+" terminal that
should be connected to the red (+) terminal on
Front Left speaker with the older color coding,
while the Red terminal is the positive, or "+"
terminal that should be connected to the red (+)
terminal on Front Right speaker. Connect the
black (–) terminals on the HS to the black (–)
terminals on the speakers. See page 14 for more
information on speaker polarity.
Remote IR Input: If the HS 250's front-
panel IR sensor is blocked due to cabinet doors
or other obstructions, an external IR sensor
may be used. Connect the output of the sensor
to this jack.
REAR PANEL CONNECTIONS
9