Advertisement
Components
1.Front Grill
2.Blade
3.Rear Guard Fixation Screws
4.Rear Grill
5.Motor Shaft
6.Motor
7.Oscillation Control
8.Control Switch
9.Knob
10.Pipe
11.Base
12.Ring
13.Base Locking Screw
Operating your Fan
Assembly
The Fan head and the pipe are assembled.
Unscrew the Fastener & Ring and Base
Locking Screw from the Pipe.
Insert the Pipe through the hole in the centre
of the Base and twist into position.
Secure the Pipe to the Base with the
Fastener, Ring and Base Locking Screw, in
that order (see picture)
Fasten the Rear Grill onto the Motor with the
four Rear Grill Screws provided.
Install the Fan Blade onto the Motor Shaft by
tightening the Blade Screw.
Centre the Front Grill by aligning the logo on
the grill Hub so it is horizontal and parallel to
the floor. Then secure the Front and Rear
Grills completely together by snapping grill
clips into place. Lastly, tighten the Grill
Locking Screw at the bottom of the Rear Grill.
Advertisement
