Advertisement
Quick Links
DDC4500T
GE
5.4 Cu. Ft. Large Capacity Modular Commercial Gas Dryer
®
Dimensions and Installation Information (in inches)
Exhaust Options: Shipped with exhaust to the rear.
Gas model offers 2-way venting: left, right, or rear.
Maximum recommended exhaust duct length is 15
feet of 4" rigid ducting with two 90° elbows and 4" a
dampered wall cap.
(See Installation Instructions.)
Requirements:
Gas – 115 Volts, 60 Hertz single phase. An individual
branch circuit, properly grounded for a 3-prong
outlet, fused for 15- or 20-amp is required for each
dryer. Gas rate input, 22000 BTU/Hr. Maintains the
thermostatically controlled heat flow to dry clothes
gently. Longer cool down period on Permanent Press
cycle helps prevent heat-set wrinkles. Separate
thermostat controls lower temperatures for Knit cycle
drying. Factory equipped for natural gas. Tested
for LP gas. A conversion kit is required for LP gas.
Check installation instructions for correct kit number.
Have a qualified technician install the conversion kit.
Equipped with energy saving Glo-Bar ignition.
For answers to your Monogram,
GE Profile
®
GE
®
appliance questions, visit our website at
geappliances.com or call GE Answer Center
800.626.2000.
Gas Dryer
only
Note: Dimensions and specifications shown here are correct at the time this sheet was printed. Before
proceeding with construction or rough-in, check installation instructions that came with your unit.
Specifications, dimensions and design are subject to change without notice.
or
Note: Wall anchor chain provided for gas models only.
™
service,
®
27
27
Front View
Cmmrcl. Front.eps
11-3/4
77
3/4
1-7/8
Rear View
DDC4400S Back View
Specification Revised 11/09
41-5/8
3-1/2
2-3/8
370405
Advertisement
Related Manuals for GE DDC4500TWH
Summary of Contents for GE DDC4500TWH
- Page 1 For answers to your Monogram, GE Profile Note: Wall anchor chain provided for gas models only. ® ™ ® appliance questions, visit our website at geappliances.com or call GE Answer Center service, ® Cmmrcl. Front.eps 800.626.2000. DDC4400S Back View Specification Revised 11/09...
- Page 2 Important Note: • The dryer MUST be exhausted to the outside. GE Kit Number WE14X70 needed when converting rear exhaust to bottom or side. • Minimum clearances between dryer cabinet and adjacent walls or other surfaces are: 0" either side (On large capacity models.)
- Page 3 • Porcelain Drum Interior • Front Serviceable • Extra-Large Door Opening • Reversible Door • Coin slide CKTHDV8 available through GE or direct from ESD (two kits are needed) • Model DDC4500TWH – White (Gas) For answers to your Monogram, GE Profile ®...