Bosch WTB86201UC Use And Care Manual page 31

Problem
The Check drain indi-
cator light up.
Water has not drained
completely.
Water is leaking out.
Program terminates
shortly after starting.
The door opens by
itself.
Creasing.
Drying result is not sat-
isfactory (laundry feels
too damp).
Drying time too long.
Program does not start
Finished in (remaining)
time is displayed.
Program does not start
- D symbol light up.
Possible cause(s)
Drain hose is blocked.
Drain hose is leaking: is not
screwed on the tight at both ends,
or rubber not placed in hose.
Dryer is not leveled.
The heat exchanger seal is dirty.
Ambient temperature greater than
° °
41 F/5 C.
Laundry is not loaded.
Load too small for selected pro-
gram.
Loaded laundry dry.
The door not closed properly.
Laundry load exceeded.
Unsuitable program selected.
Warm laundry may feel damper
than it really is.
The selected program does not suit
the load.
Dryness level is not adjusted.
Fine layer of limescale on the
humidity sensors.
Program termination e.g. main
power supply failure, door open or
maximum drying time reached.
Laundry is too wet.
Lint filter is dirty.
Insufficient supply of air.
Air inlet possibly blocked.
Ambient temperature higher than
° °
95 F/35 C.
Program ending time has been
selected and activated.
Childproof look is activated.
Solution(s)
Check drain hose.
~ Maintenance of drain hose; Page 29
Check drain hose connection conditions.
Check the drain hose, be sure that it is on the dryer
securely with the clamp in place; may need to replace
the drain hose if leaking continues.
Level the dryer.
~ Leveling the dryer; Page 14
Clean the heat exchanger seal.
~ Cleaning the heat exchanger; Page 28
Ventilate the room.
Load the laundry.
~ Loading the laundry; Page 25
Use time program.
~ Program selection table; Page 20
Check the loaded laundry. If it is dry, open the door,
remove laundry and turn program selector to Off.
Close the door until a click is heard.
Do not exceed the maximum load for selected pro-
gram. Remove items of laundry immediately after the
end of the program, hang them up and pull into shape.
Turn program selector to Off.
~ Program selection table; Page 20
Remove items of laundry immediately after the end of
the program and turn the program selector to Off.
Use another drying program or, in addition, select the
time program.
~ Program selection table; Page 20
Use Dry Level to adjust the dryness level.
~ Dry Level; Page 21
Clean the moisture sensors.
~ Cleaning the moisture sensors; Page 29
See the problem(s) mentioned in this table.
Spin laundry at higher speed in the washing machine,
before drying.
Switch off the dryer and switch on again.
Clean lint filter.
~ Cleaning the lint filter; Page 27
Ensure that air can circulate.
Do not obstruct the air inlet on the front of the dryer.
Ventilate the room.
Drying cycle will begin at proper time to complete at
the selected Finished in time.
Deactivate Childproof look.
~ Childproof lock; Page 26
31