Table of Contents
Advertisement
4.7
Wireless LAN
Removing the Wireless LAN
1.
Turn the computer upside down and loosen the embedded M2.5x5 screw securing the wireless
LAN compartment cover.
2.
Lift off the wireless LAN compartment cover.
3.
Remove the embedded one M2.5x3.6 screw securing the Mini PCI bracket.
Note: If your wireless LAN unit is an 'A' type card, then the screw will be a safety screw.
4.
Detach the two ends of the wireless LAN antenna.
5.
Gently press out on the latches. One end of the wireless LAN unit will pop up.
6.
Detach antenna cables from LAN card connector.
7.
Grasp the wireless LAN unit and pull it out.
Tecra A3/S2 Series Maintenance Manual
Figure 4-10
Removing the wireless LAN cover
4 Replacement Procedures
4-17
Advertisement
Chapters
Table of Contents
Troubleshooting
