LG DLE2701V User's Manual & Installation Instructions page 21

INSTAllATION INST UcTIONS
cONNEcTiNG ELEcTRic DRYERS {cont.)
USA ONLY
WARN|NG:
• Connect the power cord to the terminal block. Each colored wire should be connected
to same color screw. Wire color indicated on manual is connected to the same color
screw in block. Failure to follow these instructions may result in a short or overload.
• Grounding through the neutral conductor is prohibited for: (1) new branch-circuit
installations, (2) mobile homes, (3) recreational vehicles, and (4) areas where local
codes prohibit grounding through the neutral conductor.
Three-wire Connection for Electric Dryers: Power Cord
• A 3-wire connection is NOT permitted on new
construction after January 1, 1996.
A UL-Nsted strain relief is required.
Terminal
Block
UL-Listed
Strain Relief
3-Wire
Power Cord
Remove the terminal block access cover
on the upper back of the dryer. Install a
UL-Nsted strain relief into the power cord
through-hole; then thread a UL-Nsted, 30A,
240V, 3-wire, #10 AWG-rninirnurn copper
conductor power cord through the strain
relief.
..... jt
= Use a 30-amp, 240V, UL-listed power cord
with #10 AWG=rninirnum copper conductor
and closed loop or forked terminals with
upturned ends.
....... Hot
(Black) (White) (Red)
Attach the two hot leads of the power cord
to the outer terminal block screws. Attach
the neutral wire to the center terminal block
screw. Connect the external ground (if
required by local codes) to the green ground
screw. TIGHTEN ALL SCREWS SECURELY.
Reinstall the terminal block access cover.
21