Olympus VH-520 Instruction Manual page 25

ISO sensitivity
l
ISO Auto
& to
Value
Drive
o
Single
j
Sequential
O
High-Speed
Image size
6 4288×3216
4
3200×2400
3 1920×1440
7
640×480
Aspect
 4:3
P
16:9
● In certain shooting modes, some functions cannot be set. Refer to "List of settings available in each shooting
mode" (p. 49)
● The image sizes are the examples when the aspect ratio is set to [].
Registering one touch white balance Registering one touch white balance
Select [  One Touch 1] or [  One Touch 2], face the camera toward a piece of white paper or other white
object, and press the  button.
● The camera releases the shutter and the white balance is registered. When the white balance was
previously registered, the registered data is updated.
● The registered white balance data will not be cleared by turning off the power.
● Perform this procedure under the light where the pictures will be actually taken.
● When the camera settings are changed, the white balance must be registered again.
● When the white balance cannot be registered, check that the white paper fi lls the screen, and then
perform the procedure again.
Sets the ISO sensitivity.
The camera automatically sets the sensitivity with priority on image quality.
Set a smaller value to reduce noise in the picture, or a larger value to reduce blur.
Sets the sequential shooting function.
One frame is shot each time the shutter button is pressed.
The images are taken sequentially while holding down the shutter for up to
12 frames.
The camera takes up to 50 sequential shots at approximately 15 frames/sec.
Sets the number of recording pixels.
Suitable for printing pictures over A3 (11×17 in.).
Suitable for printing pictures up to A3 (11×17 in.).
Suitable for printing pictures up to A4 size (8.5×11 in.).
Suitable for using pictures on emails.
Sets the horizontal-to-vertical ratio of images.
Change the horizontal-to-vertical ratio to 4:3 when taking pictures.
Change the horizontal-to-vertical ratio to 16:9 when taking pictures.
25
EN