Garmin StreetPilot C320 Setup Manual page 2

Open this setup guide and follow the instructions to set up your c320.
Complete all of the setup steps:
Step 1: Configure your c320
Step 2: Install software and map data
Step 3: Load maps
Do not connect the USB cable to your PC until you are instructed to do so.
Step 1: Configure Your c320
1
Press and hold the
Power button to turn
on the unit.
Note: A "Low Battery"
warning may appear when
you turn on the unit. Charge
the unit for three hours.
2
Answer the configuration questions that appear. When you
see the screen that states "To use this unit, map data must be
installed," you are ready to install software and map data.
Start Here
Volume control
USB cable connector
Power button