Miele KFN 14927 SD ed Operating And Installation Instruction page 66

Changing the door hinging
^ Remove cap
bush in the door and refit on the
opposite side.
Refitting the lower door
^ Pull hinge pin
and adjustable foot
off.
^ Remove cover cap
^ Undo screws
off.
66
from the bearing
together with disc
upwards and
.
and take hinge plate
^ Unscrew part
rotate it by 180° and refit into the hole
on the opposite side of the hinge
plate.
^ Refit cover cap
^ Remove cover
holes on the opposite side.
^ Screw hinge plate
the opposite side using the two outer
long slots only. To make it possible to
align the door later, do not replace
the centre screw at this stage.
^ Important. Screw the adjustable foot
into hinge pin
^ Refit hinge pin
and adjustable foot
The notch at the bottom of the hinge
pin should face towards the back.
^ Place the lower door onto hinge pin
.
^ Close the lower door.
from hinge plate
in the other hole.
and fit it into the
into position on
as far as it will go.
together with disc
. Important.
,