Using Fm Traffic; Led Blink Codes - Garmin nüvi 650 Owner's Manual

U fM t
SinG raffic
U fM T
sinG
Use an optional FM TMC (Traffic
Message Channel) traffic receiver to
receive traffic information broadcast
over the FM Radio Data System. For
information about FM traffic receivers
and coverage areas, see
.com/traffic.
NOTE: The FM traffic receiver and
nüvi must be in data range of an FM
station transmitting TMC data to
receive traffic information.
NOTE: Garmin is not responsible
for the accuracy of the traffic
information. The FM traffic receiver
simply receives signals from the
traffic service provider and shows
that information on your nüvi.
NOTE: You do not need to activate
the subscription included with your
FM traffic receiver (if it came with
one). Your nüvi receives traffic data
as soon as it acquires satellite signals
and receives traffic signals from the
traffic service provider.

raffic
www.garmin
NOTE: You can only access the
traffic information if the nüvi is
connected to an FM traffic receiver.
To power outlet
in vehicle
Power
Status
LED
LED
NOTE: If your FM TMC traffic
receiver has an antenna with suction
cups on it, route the antenna on
your windshield vertically using the
suction cups.

LED Blink Codes

The green Power LED lights when
connected to external power. The Status
LED indicates the signal reception:
• Yellow dot-dash flashes: determining
which country you are currently in.
• Yellow solid: searching for signal.
• Red solid: momentary sync loss.
• Green solid: normal traffic data.
nüvi 600/650 Owner's Manual
To power
connector on nüvi
cradle