Display Assembly; Removing The Display Assembly - Dell Inspiron M5030 Service Manual

Back to Contents Page
Display
Dell™ Inspiron™ N5020/M5030/N5030 Service Manual
Display Assembly
Display Bezel
Display Panel
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION: Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
is not covered by your warranty.
CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
CAUTION: To help prevent damage to the system board, remove the main battery (see
computer.
Display Assembly

Removing the Display Assembly

1. Follow the instructions in Before You
2. Remove the battery (see Removing the
3. Remove the keyboard (see
4. Remove the two screws that secure the display assembly to the base of the computer.
5. Remove the palm rest (see
6. Turn the computer over and open the display as far as possible.
7. Make a note of the Wireless Mini-Card antenna cable routing and disconnect the Wireless Mini-Card antenna cable from the Wireless Mini- Card.
8. Disconnect the display cable from the connector on the system board and remove it from the routing guide.
9. Remove the two screws (one on each side) that secure the display assembly to the computer base.
10. Lift and remove the display assembly out of the computer base.
Begin.
Battery).
Removing the Keyboard).
Removing the Palm Rest).
Removing the Battery) before working inside the