Hotpoint WDAL 8640 Instructions For Use Manual

Hotpoint WDAL 8640 Instructions For Use Manual

Hide thumbs Also See for WDAL 8640:

Advertisement

Advertisement

Table of Contents
loading

Summary of Contents for Hotpoint WDAL 8640

  • Page 1: Table Of Contents

    Description of the washer-dryer and starting a wash cycle, 6-7 Control panel Indicator lights Starting a wash cycle Wash cycles, 8 Table of wash cycles WDAL 8640 Personalisation, 9 Setting the temperature Setting the drying cycle Functions Detergents and laundry, 10 Detergent dispenser drawer...
  • Page 2: Installation

    Installation 2. If the floor is not perfectly level, compensate for any Keep this instruction manual in a safe place for future unevenness by tightening or loosening the adjustable front reference. Should the appliance be sold, transferred or feet (see figure); the angle of inclination, measured accor- moved, make sure the instruction manual accompanies the ding to the worktop, must not exceed 2°.
  • Page 3 Connecting the drain hose • the supply voltage is included within the values indica- ted on the Technical Data Plate fixed on the machine. Connect the drain hose, without bending it, to a • the socket is compatible with the washer-dryer’s plug. If draining duct or a wall drain this is not the case, replace the socket or the plug.
  • Page 4: The First Wash Cycle

    As the colours of the wires in the lead may not correspond The first wash cycle with the coloured markings identifying the terminals in your Once the appliance has been installed, and before you use plug, proceed as follows: it for the first time, run a wash cycle with detergent and no Connect Green &...
  • Page 5: Specifications

    Technical data Model WDAL 8640 width 59.5 cm Dimensions height 85 cm depth 54 cm from 1 to 8 kg for the wash programme Capacity from 1 to 6 kg for the drying programme Electrical please refer to the technical data plate...
  • Page 6: Description Of The Washer-Dryer And Starting A Wash Cycle

    Description of the washer-dryer and starting a wash cycle Control panel WASH CYCLE PROGRESS indicator lights DRYING knob DOOR ON/OFF button LOCKED TEMPERATURE indicator light knob START/PAUSE button with indicator light FUNCTION Detergent dispenser drawer buttons with indicator lights WASH CYCLE knob Detergent dispenser drawer: used to dispense START/PAUSE button with indicator light: starts or tem-...
  • Page 7: Indicator Lights

    Indicator lights Door locked indicator light If this indicator light is on, the appliance door is locked to prevent it from being opened accidentally; to avoid any The indicator lights provide important information. damage, wait for the indicator light to switch off before you This is what they can tell you: open the appliance door.
  • Page 8: Wash Cycles

    Wash cycles Table of wash cycles Detergents Max. Max. Max. Cycle Description of the wash cycle temp. speed Drying load duration (kg) (°C) (rpm) Fabric Wash softener CLEAN Plus 40° 1400 180’ 1 Anti Stain    2 Whites 60°...
  • Page 9: Personalisation

    Personalisation Setting the temperature Turn the TEMPERATURE knob to set the wash temperature (see Table of wash cycles). The temperature may be lowered, or even set to a cold wash ( ). The washer-dryer will automatically prevent you from selecting a temperature which is higher than the maximum value set for each wash cycle. Setting the drying cycle Table of Drying times (guideline values)
  • Page 10: Detergents And Laundry

    Detergent dispenser drawer Garments requiring special care Successful washing results also depend on the correct Wool: the wool wash cycle on this Hotpoint machine has dose of detergent: adding too much detergent will not been tested and approved by The Woolmark Company...
  • Page 11: Precautions And Tips

    Precautions and tips Disposal This washer-dryer was designed and constructed in accordance with international safety regulations. The fol- • Disposing of the packaging materials: observe local regu- lowing information is provided for safety reasons and must lations so that the packaging may be re-used. therefore be read carefully.
  • Page 12: Care And Maintenance

    Care and maintenance Cutting off the water and electricity Caring for the door and drum of your supplies appliance • Turn off the water tap after every wash cycle. This will limit • Always leave the porthole door ajar in order to prevent wear on the hydraulic system inside the washer-dryer and unpleasant odours from forming.
  • Page 13: Troubleshooting

    Troubleshooting Your washer-dryer could fail to work. Before contacting the Technical Assistance Centre (see “Assistance”), make sure that the problem cannot be solved easily using the following list. Problem: Possible causes / Solutions: The machine does not switch on. • The appliance is not plugged into the socket fully, or not enough to make contact. •...
  • Page 14 The machine is noisy. • There will always be some motor, pump and drum noise during spin. The machine wont spin properly. • Out of Balance detected when attempting to go into a spin cycle - If this happens the machine will continue to try to repeat the distribution of the load required before the machine will go into higher spin speeds - This will increase the programme time accordingly.
  • Page 15: Assistance

    OR NON-DOMESTIC PREMISES. 5 Year Parts Guarantee Hotpoint also offers you a free 5 year parts guarantee. This additional guarantee is conditional on you registering your appliance with us and the parts being fitted by one of our authorised engineers. There will be a charge for our engineer’s time.
  • Page 16: After Sales Service

    Republic of Ireland: 0818 313 413 www.hotpointservice.co.uk Appliance Registration We want to give you additional benefits of Hotpoint ownership. To activate your free 5 year parts guarantee you must register your appliance with us. UK: 08448 24 24 24 Republic of Ireland: 01 230 0800 www.hotpointservice.co.uk...

Table of Contents