Test For Solution Spray; Cleaning The Carpet; Solution Dispening Stroke; Solution Recovery Stroke - Kenmore Sears 175.8690090 Hom? cleaning system Owner's Manual

TEST FOR SOLUTION SPRAY
See Figure 6
1. Hoki Floor Nozzle above floor level.
2. Pull Solution Release Trigger on Angled Wand.
3. Observe Floor Nozzle to make sure cleaning solution
is being sprayed evenly. (see DETAIL "A")
NOTE: If solution is not being sprayed evenly, refer to
Trouble Shooting Chart.
CLEANING THE CARPET
See Figures 7 & 8
Solution Dispensing Stroke:
1, Start at a oomer (recommended).
2. Place Floor Noz,tle so Suction Inlets are flush with
carpet.
3, While exeding light pressure down on Floor Nozzle,
depress Sotution Release tdgger and slowly pull
Floor Nozzle towards you.
NOTE: Do not overwet. Ifthree or more oleaning strokes
are required, let dry and then repeat cleaning proc-
es,s.
Solution Recovery Stroke:
1. Release Solution Release Trigger.
2. Lift Root Nozzle off carpet.
3. Return Floor Nozzle to point where you dispensed
clean{rig solution and pull across carpet, recovering
dirty solution.
Fig. 6
Fig. 7
SUCTION INLETS
LIFT,
SET FORWARD,
PULL BACK ACROSS CARPET
\
!
/
Fig. B
Page 6