Advertisement
QUICK FEATURES SETUP GUIDE
This guide is provided here for your convenience as a quick refer-
ence for performing remote control sequences.
Component Setup
x 2
T urn on
Press component
Press SET
component
key once
until Red Light
(e.g., TV).
(e.g., TV).
blinks twice;
release SET.
1
2
3
Auto Scan
x 2
T urn on
Press component
Press SET
component
key once
until Red Light
(e.g., TV).
(e.g., TV).
blinks twice;
release SET.
* NOTE: Not VOL-, SCAN, or SET.
1
2
3
Code Verification
x 2
Press component
Press SET
Enter 9-9-0;
key once
until Red Light
the Red Light
(e.g., TV).
blinks twice;
will blink twice.
release SET.
1
2
Volume Lock
x 2
Press component*
Press SET
key once (e.g., CBL).
until Red Light
blinks twice;
release SET.
* NOTE: Component must have
volume capabilities.
1
2
7
# # # #
x 2
Enter 4-digit code
Press POWER
for your brand;
once; if no
Red Light blinks
response,
twice after last #.
repeat steps
with next code.
4
5
x 2
Aim remote at
Press SET
component; press
until Red Light
SCAN once. When
blinks twice;
off, press any
release SET
key* to stop.
to lock code.
4
5
x 2
Press 1 once for 1st digit.
Wait 3 sec. and count blinks.
Number of blinks equals
value of code digit.
Repeat with 2, 3, and 4.
3
4
Press VOL+ once.
Volume now controlled
through component
selected in step 1.
3
TROUBLESHOOTING
PROBLEM:
Red Indicator Light does not
blink when you press a key.
The VOL+,VOL- and MUTE
keys are not functional.
Red Indicator Light blinks when
you press a key, but home enter-
tainment component does not
respond.
The remote control does not
control home entertainment
components or commands are
not working properly.
CH+, CH- and LAST do not
work for your RCA TV.
Changing channels does not
work properly.
Tried Auto Scan and still could
not find a working code.
NOTE:
To clear all set up codes and restore functions to Default,
press SET until red light blinks twice, release SET and enter 9-8-1.
Caution:When this clear feature is performed, please note that all of
your set up codes will be reset to the default codes and you will need
to reprogram components.
SOLUTION:
Replace the batteries with two
(2) "AA" alkaline batteries (see
Page 4).
Make sure that the volume con-
trol is locked to a component
that has volume capabilities and is
programmed into the remote
control.
Make sure you are aiming the
remote control at your home
entertainment component and
that you are within 15 feet of the
component you are trying to
control.
Try all listed codes for the com-
ponent brand being set up. Make
sure all components can be oper-
ated with an infrared remote
control.
Due to an RCA design (1983-
1987), only the original remote
control will operate these func-
tions.
If original remote control
required pressing ENTER to
change channels, to change chan-
nels, press ENTER on the
remote after entering a channel
number.
Try Auto Scan again after clearing
out the component key as fol-
lows: Press and hold SET until
Red Light blinks twice, then
release. Next enter 9-9-2. Then
press and release the component
key to be cleared twice.
8
Advertisement
