Garmin GPSMAP 400 Owner's Manual page 64

a
ppendIx
Transducer Disconnected, Sonar Turned Off—there is not a
transducer attached, bad cable/transducer, or the transducer cable
was disconnected. If the transducer cable is removed while the unit
is on, reconnect and cycle power.
Transfer Complete—the unit has finished uploading or
downloading information to the connected device.
User Card Not Found, Please Insert Card—attempted to transfer
user data without an SD card containing user data being present in
the SD card slot.
Water Speed Sensor Is Not Working—the speed sensor is not
detected. Check the connections.
Water Temperature Alarm—sonar has reported a temperature
above, below, inside, or outside the specified value(s).

Waypoint Already Exists—you entered a waypoint name that
already exists in memory. Modify the waypoint name or delete the
existing waypoint.
Waypoint Memory Full—you have used all 1,500 waypoints
available. Delete unwanted waypoints to make space for new entries.
Weather Service Lost*—the external weather you were connected
to has either been disconnected or the unit has lost communication
with the device for some other reason.
XM Service Incompatible*—the external XM antenna you are
connected to needs a software update.
* This message appears only if you have a GXM 31 antenna connected and a
subscription to XM WX Weather.
GPSMAP 400 Series Owner's Manual
®