Advertisement
Button
Press and Release Functions
SNOOZE
Trigger snooze alarm (ringing)
+/12/24
1 step forward
Fast advance
(Time set mode)
(Time set mode)
(Alarm set mode)
(Alarm set mode)
(Temperature Alert set)
(Temperature Alert set)
Select 12/24-hour time
Change Time Zone
MODE/SET
Move through program menu
Enter program menu, set
(Time set mode)
time, date, etc.
(Time set mode)
Move to Alarm Mode
Enter Alarm Set
(Alarm set mode)
(Alarm set mode)
-/C/F
1 step backward
Fast backward
(Time set mode)
(Time set mode)
(Alarm set mode)
(Alarm set mode)
(Temperature Alert set)
(Temperature Alert set)
Select Fahrenheit/ Celsius
Search WWVB signal
RESET
Press to reset clock
AL ON/OFF
Time Alarm ON/OFF
ALERT
Move to Temperature
Set Temperature Alert
Alert Mode
(High, Low)
SEARCH
Search for outdoor
Temperature transmitter
POSITIONING THE OUTDOOR TRANSMITTER
The remote temperature transmitter should be mounted vertically to avoid damage.
Place both units in the desired shaded locations, and wait approximately 1-hour
before permanently mounting the transmitter to ensure that there is proper
reception. The outdoor temperature transmitter is water resistant, not waterproof
and should not be placed anywhere it will become submerged in water or subject to
standing water or snow.
Wall Mount
Choose a location for the transmitter that is within range of the Atomic Digital Clock
and under an overhang for accuracy.
Install one mounting screw (included) into a wall leaving
approximately ½ of an inch (12.7mm) extended.
Place the transmitter onto the screw, using the hanging hole on
the backside.
To achieve a true temperature reading, mount where direct sunlight
cannot reach the outdoor transmitter. Mount the outdoor transmitter
on a North-facing wall or in any well shaded area. Under an eave or
deck rail work well. The maximum transmitting range in open air is
over 330-feet (100 meters). Obstacles such as walls, windows,
stucco, concrete, and large metal objects can reduce the range.
Place the transmitter at least 6 feet in the air to improve signal transmission.
POSITIONING THE CLOCK:
The Atomic Digital Clock should be mounted near an exterior wall with
the front or back facing toward Ft. Collin Colorado for best WWVB
reception. The Atomic Digital Clock should be six feet from other
electronics or wireless devices in order to best receive the outdoor
temperature transmitter signal.
Foldout Table Stand
Pull the stand out from the bottom center edge of the Atomic Digital
Clock, below the battery compartment. Once the foldout table stand is
extended, place the Atomic Digital Clock in an appropriate location.
Wall Mount
Hold 3 seconds
Use a straightedge to horizontally space three screw positions on
a wall to match the hanging holes on the back of the clock. Install
three mounting screws (not included) into a wall within
transmission range—leaving approximately 3/16 of an inch
(5mm) extended from the wall.
Place the Atomic Digital Clockonto the screws, using the hanging
holes on the backside.
Gently pull the Atomic Digital Clock down on the screws.
Note: Always ensure that the Atomic Digital Clock locks onto the
screws before releasing.
LOW BATTERY:
When this icon
batteries in the outdoor transmitter.
CARE AND MAINTENANCE:
Do Not Mix Old and New Batteries
Do Not Mix Alkaline, Standard, Lithium or Rechargeable Batteries
Do not expose the Atomic Digital Clock to extreme temperatures, vibration or
shock.
Keep Atomic Digital Clock dry.
Clean Atomic Digital Clock with a soft damp cloth. Do not use solvents or
scouring agents.
The Atomic Digital Clock is not a toy. Keep it out of reach of children.
The Atomic Digital Clock is not to be used for medical purpose or for public
information, but is determined for home use only.
The specifications of this Atomic Digital Clock may change without prior notice.
Improper use or unauthorized opening of housing will void the warranty.
If the Atomic Digital Clock does not work properly, change the batteries.
SPECIFICATIONS:
Temperature Range:
Indoor:
Outdoor:
Distance:
Power requirements:
Atomic Digital Clock:
KW5012FSK Transmitter:
Battery Life:
KW5012FSK Transmitter
Battery Life:
Atomic Digital Clock
Battery Life:
Dimensions:
Atomic Digital Clock:
KW5012FSK Transmitter:
WARRANTY INFORMATION
La Crosse Technology, Ltd provides a 1-year limited warranty on this product
against manufacturing defects in materials and workmanship.
This limited warranty begins on the original date of purchase, is valid only on
products purchased and used in North America and only to the original purchaser of
this product. To receive warranty service, the purchaser must contact La Crosse
Technology, Ltd for problem determination and service procedures. Warranty
service can only be performed by a La Crosse Technology, Ltd authorized service
center. The original dated bill of sale must be presented upon request as proof of
purchase to La Crosse Technology, Ltd or La Crosse Technology, Ltd's authorized
service center.
La Crosse Technology, Ltd will repair or replace this product, at our option and at no
charge as stipulated herein, with new or reconditioned parts or products if found to
be defective during the limited warranty period specified above. All replaced parts
and products become the property of La Crosse Technology, Ltd and must be
returned to La Crosse Technology, Ltd. Replacement parts and products assume
the remaining original warranty, or ninety (90) days, whichever is longer. La Crosse
appears in the outdoor (OUT) readings section, replace the
+32°F to +122°F (0°C to 50°C)
-4°F to 122°F (-20°C to 50°C)
Over 330 ft. (100 meters)
RF 915MHz (open air)
3-C, IEC, LR14 batteries (not included)
2-AA, IEC, LR6 batteries (not included)
Battery life is over 12 months when using
reputable battery brands.
Battery life is over 12 months when using
reputable battery brands.
16.14" W x 1.69" D x 10.63" H
(410 x 43 x 270 mm)
3" W x 0.79" D x 4.45" H
(75 x 0.79 x 113mm)
2
Technology, Ltd will pay all expenses for labor and materials for all repairs covered
by this warranty. If necessary repairs are not covered by this warranty, or if a
product is examined which is not in need or repair, you will be charged for the
repairs or examination. The owner must pay any shipping charges incurred in
getting the La Crosse Technology, Ltd product to a La Crosse Technology, Ltd
authorized service center. La Crosse Technology, Ltd will pay ground return
shipping charges to the owner of the product to a USA address only.
The La Crosse Technology, Ltd warranty covers all defects in material and
workmanship with the following specified exceptions: (1) damage caused by
accident, unreasonable use or neglect (including the lack of reasonable and
necessary maintenance); (2) damage occurring during shipment (claims must be
presented to the carrier); (3) damage to, or deterioration of, any accessory or
decorative surface; (4) damage resulting from failure to follow instructions contained
in the owner's manual; (5) damage resulting from the performance of repairs or
alterations by someone other than an authorized La Crosse Technology, Ltd
authorized service center; (6) units used for other than home use (7) applications
and uses that this product was not intended or (8) the products inability to receive a
signal due to any source of interference.. This warranty covers only actual defects
within the product itself, and does not cover the cost of installation or removal from
a fixed installation, normal set-up or adjustments, claims based on
misrepresentation by the seller or performance variations resulting from installation-
related circumstances.
LA CROSSE TECHNOLOGY, LTD WILL NOT ASSUME LIABILITY FOR
INCIDENTAL, CONSEQUENTIAL, PUNITIVE, OR OTHER SIMILAR DAMAGES
ASSOCIATED WITH THE OPERATION OR MALFUNCTION OF THIS PRODUCT.
THIS PRODUCT IS NOT TO BE USED FOR MEDICAL PURPOSES OR FOR
PUBLIC INFORMATION. THIS PRODUCT IS NOT A TOY. KEEP OUT OF
CHILDREN'S REACH.
This warranty gives you specific legal rights. You may also have other rights
specific to the State. Some States do not allow the exclusion of consequential or
incidental damages therefore the above exclusion of limitation may not apply to you.
For warranty work, technical support, or information contact:
La Crosse Technology, Ltd
2817 Losey Blvd. S.
La Crosse, WI 54601
Contact Support: 1-608-782-1610
Product Registration:
www.lacrossetechnology.com/support/register
Protected under U.S. Patents:
The complete instruction manual is available at:
www.lacrossetechnology.com/513-1311ot
FCC DISCLAIMER
This Device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and
(2) the device must accept any interference received, including interference that
may cause undesired operation.
NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV
INTERFERENCE CAUSED BY UNAUTHORIZED MODIFICATIONS TO THIS
EQUIPMENT. SUCH MODIFICATIONS COULD VOID THE USER AUTHORITY TO
OPERATE THE EQUIPMENT
All rights reserved. This handbook must not be reproduced in any form, even in
excerpts, or duplicated or processed using electronic, mechanical or chemical
procedures without written permission of the publisher.
This handbook may contain mistakes and printing errors. The information in this
handbook is regularly checked and corrections made in the next issue. We accept
no liability for technical mistakes or printing errors, or their consequences.
All trademarks and patents are acknowledged.
5,978,738
6,076,044
6,597,990
Advertisement
