Washer Use - Galaxy washer Use And Care Manual

WASHER USE
Fire Hazard
Never place items in the washer that are dampened
with gasoline or other flammabme fluids°
No washer can compmeteBy remove oil
De not dry anything that has ever had any type of oH on
it (incmuding cooking oHs)o
Doing so can resumt in death, explosion, or fire.
Electrica_ Shock Hazard
Pmuginto a grounded 3 prong eutieto
De not remove ground prong.
Do not use an adapter,
Do not use an extension cord°
Failure to fellow these }nstructiens can reeumt }n death,
fire, or electrfcam shock.
1.
2.
3.
4.
Measure detergent and pour it into the washer. If desired, add
powdered or liquid color safe bleach.
Drop a sorted load of clothes loosely into your washer.
• Load evenly to maintain washer balance. Mix large and
small items. Items should move easily through the wash
water.
Load only to the top of the basket as shown. Overloading
can cause poor cleaning.
(Optional Step) Add liquid chlorine bleach.
• Let the washer fill and begin agitating the load.
Add bleach 5 minutes into the wash cycle for best
cleaning and so that bleach can be removed in the rinse
cycle. Pour bleach around the agitator, not directly onto
the load to avoid damaging clothing or other items in the
load.
NOTE: Follow the garment and the chlorine bleach
manufacturers' directions for proper use. Undiluted bleach
will damage any fabric it touches. The damage appears as
rips, holes, tears, or color loss and may not show up until
several washings later. To avoid spilling, use a cup with a
pouring spout. Do not let bleach splash, drip, or run down
into the washer basket. Always measure liquid chlorine
bleach. Do not guess. Do not use more than the
manufacturer's recommended amount for a full load. Use less
with a smaller load size.
(Optional Step) Add liquid fabric softener.
• In the final rinse only, add fabric softener that has been
diluted with 1/2to 1 cup (125 to 250 mL) warm water.
NOTE: Do not spill or drip any fabric softener onto the
clothes. Undiluted fabric softener can stain fabrics. Always
dilute fabric softener with warm water. Too much fabric
softener can make some items (diapers and towels)
nonabsorbent. If this happens, do not use it every load, or
use less of it in each load.
5. Close the washer lid.
6. Set the TEMPERATURE selector to the correct setting for the
type of fabric and soils being washed. Use the warmest wash
water safe for fabric. Follow garment label instructions.
Water Temp Use for
Warm Heavy soils
Bright colors
Whites and pastels
Moderate to light soils
Cold Colors that bleed or fade
Light soils
NOTE: In wash water temperatures colder than 60°F (15.6°C),
detergents do not dissolve well. Soils can be difficult to
remove. Some fabrics can retain wear wrinkles and have
increased pilling (the formation of small lint-like balls on the
surface of garments).
7. Push in the Cycle Control knob and turn it clockwise to the
wash cycle you want. Pull out the Cycle Control knob to start
the washer.
To stop or restart your washer:
• TO stop the washer at any time, push in the Cycle
Control knob.
• TO restart the washer, close the lid (if open) and pull out
the Cycle Control knob.