Baumatic BRCIF7535 266 Instruction Manual page 23

Insert the retaining screws (1) into the opposite side of the
o
appliance from their original position. The
partially tightened but not fully tightened.
Remove the door retaining screws (2) and then reverse the
o
position of the
on page 23).
Reattach the appliance door and then fully re-tigh
o
retaining screws (1) and the door retaining screws (2).
Insert the cover caps (3) into the h
o
the right hand side of the cabinet.
IMPORTANT: Check that the door opens and shuts correctly,
without f ouling, after you have completed the door reversal
p rocess.
After the door has been reversed, you should check
the door seal of the appliance. The seal should not
be creased or crushed; otherwise there
b etween it and the inside of the door.
The seal must adhere properly all the way around the door.
o
If the seal is n
o
should either:-
1. Use a warm damp cloth and manipulate the seal until it doe
adhere to the cabinet properly, all the way around the door.
or
2. Use a hair dryer on its lowest heat setting and lightly heat the
areas of the door seal that are not adhering correctly. The
heat will make the seal more pliable and this
manipulate the seal into the correct position.
IMPORTANT: DO NOT HEAT THE DOOR SEAL ON ANYTHING BUT
THE LOWEST HEAT SETTING, OR HEAT THE SEAL FOR A LONG
PERIOD OF TIME. OTHERWISE DAMAGE MAY BE CAUSED TO
THE DOOR SEAL, WHICH WOULD
T HE GUARANTEE FREE OF CHARGE.
IMPORTANT: WHEN YOU HAVE REVERSED THE DOORS OF THE
APPLIANCE. IF YOU HAVE PLACED THE APPLIANCE ON ITS
SIDE, YOU MUST WAIT
APPLIANCE BACK ON.
top and bottom hinge (as shown in the diagram
ot adhering to the cabinet properly, then you
FOR 8 HOURS BEFORE SWITCHING THE
se screws should be
oles that are now exposed on
will be a gap
will allow you to
NOT BE RECTIFIED UNDER
ten the
s
23