Basic Operation - Panasonic WV-CP500/G Operating Instructions Manual

Basic operation

The description below explains how to operate the setup menu basically.
The operations in the setup menu are performed with the operation buttons after calling up the setup menu on the connected
video monitor. Refer to the installation guide for further information about the operation buttons.
The operations in the setup menu can also be performed through the system controller (option).
Screenshot 1
Hold down the setting button for approx. 2 seconds to call
up the top screen of the setup menu.
MODEL WV-CP500 SERIES
CAMERA ID
CAMERA
SYSTEM
BACK-FOCUS
SPECIAL
LANGUAGE
END SETUP DISABLE
Screenshot 2
The setup mode changes to "ENABLE", and the setup menu
becomes ready to be set.
MODEL WV-CP500 SERIES
CAMERA ID
CAMERA
SYSTEM
BACK-FOCUS
SPECIAL
LANGUAGE
END SETUP ENABLE
Screenshot 3
The selected setup screen in the setup menu appears on
the screen.
**CAMERA SETUP**
SCENE1
ALC/ELC
SHUTTER
AGC
SENS UP
WHITE BAL
DNR
BW MODE
i-VMD
RET TOP END
Note:
• If the top screen of the setup menu is called up with the
operation buttons while a camera image is displayed,
the setup mode is always "DISABLE" to prevent opera-
tion errors.
To configure the settings in the setup menu, change the
setup mode to "ENABLE".
• The cursor is a reversely highlighted part.
OFF
OFF
ALC
OFF
ON(HIGH)
OFF
ATW1
HIGH
AUTO1
Step 1
Press the up button or the down button to move the cursor
to "END".
Step 2
Press the right button to move the cursor to "SETUP", and
press the setting button to change the setup mode from
"DISABLE" to "ENABLE".
Step 3
Move the cursor to the item to be set, and press the setting
button.
Step 4
Perform the settings for each item.
• Selection of setting item:
Press the up button or down button to move the cursor.
• Change of settings:
Press the right button or left button.
• Display of advanced setup screen:
Press the setting button when "O" is attached to the tar-
get setting item.
• Return to previous setup screen:
Move the cursor to "RET" and press the setting button.
• Return to the top screen:
Move the cursor to "TOP" and press the setting button.
Step 5
To return to the camera image screen, move the cursor to
"END" and press the setting button.
5