Bosch GP712VS Operating/Safety Instructions Manual page 3

Disconnect the plug from the power source
and/or the battery pack from the power tool
before making any adjustments, changing
accessories, or storing power tools.
Store idle power tools out of the reach of
children and do not allow persons unfamiliar
with the power tool or these instructions to
operate the power tool.
Maintain power tools. Check for misalignment
or binding of moving parts, breakage of
parts and any other condition that may
affect the power tool's operation. If damaged,
have the power tool repaired before use.
Power Tool-Specific Safety Warnings
Safety Warnings Common for
Sanding, Wire Brushing, and
Polishing Operations:
This power tool is intended to function as a
sander, wire brush or polishing tool. Read
all safety warnings,
illustrations and specifications provided
with this power tool.
Operations such as grinding or abrasive
cutting off is not recommended to be
performed with this power tool.
Do not use accessories which are not
specifically designed and recommended by
the tool manufacturer.
The rated speed of the accessory must be
at least equal to the maximum speed
marked on the power tool.
The outside diameter and the thickness of
your accessory must be within the capacity
rating of your power tool.
Keep cutting tools sharp and clean.
Use the power tool, accessories and tool
bits etc. in accordance with these instructions,
taking into account the working conditions
and the work to be performed.
Have your power tool serviced by a qualified
repair person using only identical
replacement parts.
The arbor size of wheels, flanges, backing
pads or any other accessory must properly
fit the spindle of the power tool.
instructions,
Do not use a damaged accessory. Before
each use inspect the accessory such as
abrasive wheels for chips and cracks,
backing pad for cracks, tear or excess wear,
wire brush for loose or cracked wires. If
power tool or accessory is dropped, inspect
for damage or install an undamaged
accessory. After inspecting and installing
an accessory, position yourself and
bystanders away from the plane of the
rotating accessory and run the power tool
at maximum no-load speed for one minute.
Wear personal protective equipment.
Depending on application, use face shield,
safety goggles or safety glasses. As
appropriate, wear dust mask, hearing
protectors, gloves and workshop apron
capable of stopping small abrasive or
workpiece fragments. The eye protection
must be capable of stopping flying debris
generated by various operations.
Service