Changing The Fuse; Removing The Nüvi And Mount; Mounting On Your Dashboard - Garmin 800 Owner's Manual

Appendix

Changing the Fuse

CAUTiON: When replacing the fuse,
do not lose any of the small pieces
and make sure they are put back in the
proper place.
If your unit will not charge in your
vehicle, you might need to replace the
fuse located at the tip of the vehicle
adapter.
1. Unscrew the black,
round end piece, and
remove it.
2. Remove the fuse
(glass and silver
cylinder), and
replace it with a 3 A
fast-blow fuse.
3. Ensure that the silver tip is placed in
the black end piece. Screw on the
black end piece.

Removing the nüvi and
Mount
To remove the nüvi from the cradle,
press the button on the bottom of the
cradle up, and tilt the nüvi forward.
To remove the cradle from the mount,
turn the cradle to the right or left. Apply
pressure in that direction until the cradle
snaps off the mount.
End End
To remove the suction cup mount from
piece piece
the windshield, flip the lever toward you.
Silver tip Silver tip
Pull the tab on the suction cup toward
Fuse Fuse
you.
Mounting on Your
Dashboard
Use the enclosed ounting disk to mount
your unit to the dashboard and comply
with certain state regulations.
CAUTiON: The permanent
mounting adhesive is extremely
difficult to remove after it is installed.
nüvi 800 Series Owner's Manual