Getting Started - D-Link DIR-625 Router Quick Start Manual

GETTING STARTED

The Quick Start Guide will lead you through a 3-step process to install Securespot 2.0 Services on your
D-Link DIR-625 router consisting of:
1. Upgrading the firmware for your DIR-625 router
2. Activating your Securespot 2.0 services and creating your Securespot 2.0 account
3. Completing an initial configuration of Securespot services
The total time for this process is approximately 5 minutes.
BEFORE YOU BEGIN
1. Check the Hardware Version of your DIR-625
Securespot 2.0 will only run on Revision C1 of the DIR-625 router. Please verify the version
number of your router by checking the sticker on the back (see picture below). Attempting to
upgrade a DIR-625 router that is not H/W Ver C1 can damage it.
2. Ensure that you are connected to the router with an ethernet cable
Do NOT attempt a firmware upgrade from a wireless connection. You could damage your router
due to the increased packet loss from a wireless connection. Be sure you are connected to your
DIR-625 with an Ethernet cable.
3. Make sure that your router is connected to the Internet
This guide is intended for previously installed DIR-625 routers.
recommended that you first install your DIR-625 using its installation CD, and ensure it is
operating correctly and communicating with the internet.
Quick Start Guide
For new routers, it is