DOD 410 SERIES II Owner's Manual

R410 Manual 6/8/99 10:41 AM
A T T E N T I O N :
W A R N I N G :
S H O C K D O N O T E X P O S E T H I S E Q U I P M E N T T O R A I N O R M O I S T U R E
The symbols shown above are internationally accepted symbols that warn of
potential hazards with electrical products. The lightning flash with arrowpoint in an
equilateral triangle means that there are dangerous voltages present within the
unit. The exclamation point in an equilateral triangle indicates that it is necessary
for the user to refer to the owner's manual.
These symbols warn that there are no user serviceable parts inside the unit. Do
not open the unit. Do not attempt to service the unit yourself. Refer all servicing
to qualified personnel. Opening the chassis for any reason will void the manufac-
turer's warranty. Do not get the unit wet. If liquid is spilled on the unit, shut it off
immediately and take it to a dealer for service. Disconnect the unit during storms
to prevent damage.
U.K. MAINS PLUG WARNING
A moulded mains plug that has been cut off from the cord is unsafe. Discard the
mains plug at a suitable disposal facility. NEVER UNDER ANY CIRCUMSTANCES
SHOULD YOU INSERT A DAMAGED OR CUT MAINS PLUG INTO A 13 AMP
POWER SOCKET. Do not use the mains plug without the fuse cover in place.
Replacement fuse covers can be obtained from your local retailer. Replacement
fuses are 13 amps and MUST be ASTA approved to BS1362.
SAFETY INSTRUCTIONS (EUROPEAN)
NOTICE FOR CUSTOMERS IF YOUR UNIT IS EQUIPPED WITH A POWER
CORD.
WARNING: THIS APPLIANCE MUST BE EARTHED.
The cores in the mains lead are colored in accordance with the following code:
GREEN and YELLOW - Earth
As colors of the cores in the mains lead of this appliance may not correspond with
the colored markings identifying the terminals in your plug, proceed as follows:
• The core which is colored green and yellow must be connected to the ter-
minal in the plug marked with the letter E, or with the earth symbol, or col-
ored green, or green and yellow.
• The core which is colored blue must be connected to the terminal marked
N or colored black.
• The core which is colored brown must be connected to the terminal marked
L or colored red.
Page 1
C A U T I O N
R I S K O F E L E C T R I C S H O C K
D O N O T O P E N
R I S Q U E D E C H O C E L E C T R I Q U E - N E P A S O U V R I R
T O R E D U C E T H E R I S K O F F I R E O R E L E C T R I C
BLUE - Neutral
1
BROWN - Live