Panasonic SC-HTB770 Owner's Manual page 35

iiiiii!i O r.ors
• Remote control code
When other Panasonic devices respond to this system's
remote control, change the remote control code on this
system and the remote control.
Preparation
• Turn off all other Panasonic products.
• Turn on the main unit.
Change the remote control code to code 2:
1 Aim the remote control at the main unit's
remote control sensor.
2 Press and hold [MUTE] and [0] on the remote
control for more than 4 sec.
• All the indicators will blink for 10 sec when the code of
this system is changed.
• The setting is maintained until it is changed again.
_]
• If the main unit does not operate after changing the code,
repeat steps 1 and 2.
• To change the remote control code to code 1, repeat the
steps above, but replace [0 ] with [INPUT SELECTOR].
• To reduce the clear-mode dialog effect
When the dialog does not sound natural while the volume
is set low, it is possible to reduce the dialog enhancing
effect as follows:
While pressing and holding [SOUND] on the
remote control, press and hold [- VOL] on the
main unit for more than 4 sec.
• All the indicators wilt blink once when the clear-mode dialog
effect is reduced.
• Even if clear-mode dialog effect is reduced, dialog effect
level is still adjustable.
_]
To reset the setting, return to the factory preset. (=_ 36)
• To turn offVIERA Link "HDAVI
Control"
When "HDAVI Control" compatible equipment does not
work well with this system, for example, it is possible to
turn off this function as follows:
• When VIERA Link is turned off, the ARC function is not
available. Be sure to connect the optical digital audio
cable. (=_ 26)
1 While pressing and holding [MUTE] on the
remote control, press and hold [- VOL] on the
main unit for more than 4 sec.
2 After the setting has changed, turn off all the
connected devices and then turn them on
again.
• All the indicators wilt blink once when VIERA Link "HDAVI
Control" is turned off.
_]
To reset the setting, return to the factory preset. (q_ 36)
• To turn off the volume limitation
If a state of the lowered volume disturbs you every time
the main unit turns on, for example, it is possible to turn off
this function as follows:
While pressing and holding [MUTE] on the remote
control, press and hold [VOL +] on the main unit
for more than 4 sec.
• All the indicators witt blink once when the volume limitation
is turned off.
_]
To reset the setting, return to the factory preset. (=_ 36)
RQT9778
35