Px600.2 - JBL Power BPX1100.1 Owner's Manual

4
APPLICATIONS – PX600.2
The JBL Px600.2 amplifier can be Figure 4. The JBL Px600.2
set up for stereo or bridged-mono oper- amplifier is set to stereo mode
ation, as shown in Figures 4 and 5. to drive a pair of full-range
speakers.
NOTE: For simplicity, Figures 4 and 5
do not show power, remote and input
connections.
Figure 5. The JBL Px600.2
amplifier is set to bridged (mono)
mode to drive a single
subwoofer. Use this mode only
when the nominal impedance
of the subwoofer is 4 ohms
or greater.
NEON

Px600.2

Px600.2
(rear panel)
Set MODE to FLAT;
INPUT MODE to ST
(on input panel)
X-OVER
FREQ
32Hz 320Hz
FLAT HP LP
ST MO
12dB 24dB
MODE INPUT
SLOPE
MODE
FREQ and SLOPE have no effect
NEON
Px600.2
Px600.2
(rear panel)
Set MODE to LP;
INPUT MODE to MO
(on input panel)
X-OVER
FREQ
32Hz 320Hz
FLAT HP LP
MO
ST
12dB 24dB
MODE INPUT
SLOPE
MODE
See "Setting the Crossover(s)"
on page 6 to set FREQ and SLOPE
For Stereo or Mono signals, use
both L/R inputs
GND REM BATT
BRIDGED
STEREO R L
POWER FUSES SPEAKER OUTPUTS
R Speaker L Speaker
GND REM BATT
BRIDGED
STEREO R L
POWER FUSES SPEAKER OUTPUTS
Subwoofer (4 ohms or greater)
NEON
NEON