Installing The Unit; Removing The Unit - Kenwood KDC-4051UM Instruction Manual

ISO connectors
Pin Color and function
A4 Yellow
A5 Blue/White
A7 Red
A8 Black
B1 / B2 Purple ª / Purple/black
ª
B3 / B4 Gray / Gray/black
ª
B5 / B6 White / White/black
ª
B7 / B8 Green / Green/black

Installing the unit

1
2
Before attaching, make sure the direction of
the escutcheon is correct.
(Wider hooks on the top side.)
Installing without using the mounting sleeve (Japanese car)
(KDC-U449/ KDC-U3049/ KDC-U349 only)
1 Remove the mounting sleeve and
escutcheon from the unit.
2 Align the holes in the unit (on both sides)
with the vehicle mounting bracket and
secure the unit with the supplied screws.

Removing the unit

1 Detach the faceplate.
2 Engage the catch pin on the removal tools into
the holes on both sides of the escutcheon, then
pull it out.
3 Insert the removal tools deeply into the slots on
each side, then follow the arrows instructions as
on the right.
18
Battery
Power control
Ignition (ACC)
Earth (ground) connection
· Rear speaker (right)
·
Front speaker (right)
·
Front speaker (left)
·
Rear speaker (left)
Connecting the ISO connectors on some VW/Audi or
Opel (Vauxhall) automobiles
You may need to modify the wiring of the supplied wiring
harness as illustrated below.
Ignition wire
(Red)
Unit
Battery wire
(Yellow)
Connect the wiring harness to the unit. Other
wiring connection has been completed earlier.
(page 17)
Bend the appropriate tabs
to hold the mounting sleeve
firmly in place.
A7 (Red)
Vehicle
A4 (Yellow)
Default wiring
Dashboard of your car
T: Toyota cars
N: Nissan cars