Cadence Momentum CSA SERIES Owner's Manual page 11

4 CHANNEL AMP BRIDGED TO 2 CHANNELS (CSA 1000.4)
When bridging the four channel amplifier, make sure that your final woofer impedance on each bridged channel is no lower than 4 ohms. Set the Crossover mode
switch to Low Pass and begin by setting the crossover frequency control to 100Hz and tuning from there.
RIGHT SUBWOOFER
MINIMUM IMPEDANCE
LEFT SUBWOOFER
MINIMUM IMPEDANCE
4 OHMS
CH3 CH4
CH3
CH4
4 OHM
BRIDGED
CH1 CH2
4 OHM BRIDGED
4 OHMS
POWER INPUT
FUSES
+12V REM GND
10